(800) 853-2651
SHOP NOW

Recent content by Cecil09

Yesterday's Tractor Forums
  1. C

    Farmall h sputtering and stalls under load

    So I’m at a loss guys and need some help. Not sure what has ha Opened but it seems worse now if that’s possible. Initially it started and drove just stalled under load. I’ve replaced plug wires attempted to adjust carb (idle air mixture screw 1 1/2 open and main adjusting screw 2 1/2 open) and...
  2. C

    Farmall h sputtering and stalls under load

    So I’m at a loss guys and need some help. Not sure what has ha Opened but it seems worse now if that’s possible. Initially it started and drove just stalled under load. I’ve replaced plug wires attempted to adjust carb (idle air mixture screw 1 1/2 open and main adjusting screw 2 1/2 open) and...
  3. C

    Farmall h sputtering and stalls under load

    So my inexperience is showing a little. The loose valves are actually push rods I think.
  4. C

    Farmall h sputtering and stalls under load

    Decided to go back out and take a look at the tractor again. Pulled the valve cover and started it up. I adjusted the carburetor a little more I got it to idle a little bit better but is soon as I give it throttle fireballs out the exhaust and just pops. I did notice the valves are all really...
  5. C

    Farmall h sputtering and stalls under load

    I was fiddling with the tractor going today. Got a new plug wires with a copper core. Set the engine at top dead center and the rotor button points to where the number one spark plug wire should go at approximately 2 o’clock. Put all the plug wires on started up and it runs but it’s popping...
  6. C

    Farmall h sputtering and stalls under load

    Much appreciated guys. I’ll look into the wires. I was just going to order off of Steiner but ill check Napa. Then I’ll double check timing. Once I get tdc how do I time the distributor? Or make sure it’s timed correctly.
  7. C

    Farmall h sputtering and stalls under load

    so it looks like I need new spark plug wires. I pulled one out of the cap and the connector was still inside the cap. I also need to try figure out this timing situation. So the block Is stamped 1342 when looking at the engine on the spark plug side number one cylinder is all the way to the...
  8. C

    Farmall h sputtering and stalls under load

    I really don’t want to turn this into an arguing contest about what is better for what. I would just like to get my tractor up and running again.
  9. C

    Farmall h sputtering and stalls under load

    Yes. All new plugs. If I pull wire off cap and hold 1/4” away I see blue/white spark. When I remove from 1-2 I hear a change in idle. No change when I pull 3-4 but I do see spark at the Cap to the wire.
  10. C

    Farmall h sputtering and stalls under load

    Yes. All new plugs. If I pull wire off cap and hold 1/4” away I see blue/white spark. When I remove from 1-2 I hear a change in idle. No change when I pull 3-4 but I do see spark at the Cap to the wire.
  11. C

    Farmall h sputtering and stalls under load

    Thanks. I’ll give that a try and report back.
  12. C

    Farmall h sputtering and stalls under load

    Compression checks at 80-85 on all cylinders. What do I look for when I turn the fan?
  13. C

    Farmall h sputtering and stalls under load

    Clean air cleaner
  14. C

    Farmall h sputtering and stalls under load

    Good blue spark Good flow out carb I tried to change the order to 1-3-4-2 (top right-clockwise) and it ran horrible. The weird thing is that it happened over night. Nothing was changed to make this happen. It has to be running on 2 cylinders if the idle does not change when you pull a wire right?
  15. C

    Farmall h sputtering and stalls under load

    wires “look ok” not sure if graphite or not. Fuel line is clear all new
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top