(800) 853-2651
SHOP NOW

Recent content by centash

Yesterday's Tractor Forums
  1. C

    Rhythmic bumps while moving

    Flat spotting from sitting? More likely a tire going bad, belts or cords have split, resulting in a bulge in the tire. Ben
  2. C

    MH55 oil filter

    Can't recall what I used, but I think it's the same filter as a 44. Best perhaps to wait the 10 days for the right one. Ben
  3. C

    Massey Harris running gear

    Maybe a Massey combine of that era would have a similar spindle. Probably easier to weld on an aftermarket assembly. Ben
  4. C

    JD 1640 Rough Idle and Fuel Leaks

    Injectors?
  5. C

    1974 JD 2030 Diesel

    You could try to bleed the entire system, maybe change the fuel filters....if that doesn't help, you may have pump issues. Ben
  6. C

    Gleaner M2

    Can't go wrong with that one. I had an M3 for about 15 years, rolled almost 2000 hours on it with minimal downtime. Mine was a hydro with the 426 engine, the 301 might be a bit underpowered with a hydro trans and a 6 row in soft field conditions. Get the manuals and keep it serviced...an easy...
  7. C

    44 Standard battery ground connection

    That would be a factory connection... Ben
  8. C

    Massey 44 Questions

    Access to the oil pump pick up screen to clean it.
  9. C

    30" 8 bolt rims for 1830

    Fawcetts in St Mary's....
  10. C

    Would like some help picking a Ford 4000 or talk me into another model.

    Ford 4000 or 4600, MF 165 or a JD 1120 are about the same size and your best bet in the used tractor market. Can't go wrong with a good one of any of these. Ben
  11. C

    Question for the cow experts

    On dairy cows, extra teats were cut off at birth....since you couldn't milk them, they were a source of contamination if they leaked. On a nursing beef cow, I don't think they would hurt anything. Ben
  12. C

    Gleaner A raddle chain repair

    If you are combining corn, you may want to get the saddle cob shield...fits behind the saddle chain and prevents cobs from following the chain around and go under the saddle floor where they get pinched between the saddle and the floor, and then the clutch slips. Also, check your saddle floor is...
  13. C

    Gleaner A raddle chain repair

    Looks as good as new! Ben
  14. C

    Gleaner A Iowa auction

    Looks like it was added on with the stripes. You can see the AC medallion in front of the steering wheel. Ben
  15. C

    John Deere 2555 Loader Seems Slow

    Maybe a dumb response, but are the hoses from the cylinders connected to the right valve ports on the valve body? Should be a detent forward on the boom control....float...and a detent on the dump function for quick dumps. That's how mine operated, identical valve control and loader as yours. Ben
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top