(800) 853-2651
SHOP NOW

Recent content by chartwe5

Yesterday's Tractor Forums
  1. C

    9N Overheating

    if the radiator flues are stopped up inside what is the best way to unblock them
  2. C

    9N Overheating

    I have gotten my 9N back together finally, still a few bugs, but at the moment it overheats after running for about 15 mins, i replaced the hoses and the thermostat, but still overheats, is there anything that typically causes this issue on the 9's
  3. C

    2N WIRING

    Thanks I appreciate everyones help, I will post tomorrow and let you know what i find
  4. C

    2N WIRING

    Thanks Dell, I am going to try that first thing in the morning, i will let all you guys know what happens, lets hope the MAG does not need rebuild, if i need to get it rebuilt what is a fair price to pay for your MAG to get rebuilt any ideas
  5. C

    2N WIRING

    Hey Dell this may sound stupid but where will i see the sparks...
  6. C

    2N WIRING

    The Toggle switch was to kill power, probably custom install
  7. C

    2N WIRING

    Hey Dell, No i never did check for "SPARKIES" how can i do that, this would tell me if the MAG needs rebuilt, what about the points inside tha MAG, could that be part of the problem ????
  8. C

    2N WIRING

    No Spark at the Plug ???
  9. C

    2N WIRING

    Hello, I have been on vacation for a while but i am back trying to get my 2N running, to recap my problem, i am wiring a 1941/2 2N. Which from what i have come to realize is a custom wiring that i have inherited through a purchase, i have restored her up to this point the WIRING, when i say...
  10. C

    2N WIRING

    Actually, tonight i will be working on it,so hopefully i will have some luck, i will post tomorrow
  11. C

    2N WIRING

    Ok, I put the ground to one of the mounting bolts, my mistake was i put it to the small post instead, and then to the block, ok simple fix, Thanks...
  12. C

    2N WIRING

    battery power has never been to the mag
  13. C

    2N WIRING

    I have looked for a diagram but i have not seen any showing a mag, and i have a unusual situation, the tractor ran fine until the tear down, but i have a 12V ALT with the mag, starter sylinoid and vaoltage reg.
  14. C

    2N WIRING

    What do you do to time the mag ????
  15. C

    2N WIRING

    Hi all, This is a continued post from last week to all that remember my, we'll use the polite word CUSTOM WIREING on a 2N with a Magneto, pulled all the wires off, so i can start fresh, first i just want to get her started, then i will wire for charging, so i hooked my battery cables up neg...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top