Recent content by Chris Ford

  1. C

    60 transmission

    I recently bought an Oliver 60. Engine serial ID tag puts it at a 1948. Previous owner put the shifting pattern on the transmission with a black marker. Three speeds forward One reverse. This is all I can find shifting the stick to any position. What gives? This should be a four-speed or the...
  2. C

    Hydraulic fluid

    O wow! thank you.
  3. C

    Hydraulic fluid

    I've got a late model 1650. Has gotten water in hydraulics any tips on getting it all out without having to go through 5 5 gallon buckets full cycling new through the system
  4. C

    1650 steering

    Ill dig deeper when i get time to get back to it . But i think your right
  5. C

    1650 steering

    I have not got a chance to get back to it yet. My reservoir is full and as I say my 3-point works good and the remotes with nothing hooked up bottom out and drag the Tractor Down. The book says that the system is self bleeding I tend to disagree with that
  6. C

    1650 steering

    I agree Greg.
  7. C

    1650 steering

    No sir. Only disconected 2 at cooler and 2 at rack$pinion box and they are correct. It worked for bout 5 to 10 mins.seams like air but book says its self bleading
  8. C

    1650 steering

    Sorry Albert I use the microphone for typing easier to talk than it is to type. But it doesn't always catch the words correctly. No pinched lines and as I said I pulled the diverter valve apart check the plunger everything appeared to be clean. Thank you
  9. C

    1650 steering

    Thanks for the reply. Nope inch blinds I pulled the plunger at the priority valve did not appear to be anything there
  10. C

    1650 steering

    Thanks for the reply but it's in the Hydraulics nothing is broke mechanically. Steering wheel is very hard to turn and no hydraulic action
  11. C

    1650 steering

    When I say tires will not follow it is not because steering shaft is broke. There is heavy resistance on the steering wheel but no action at the
  12. C

    1650 steering

    Steering was working fine as I pulled the tractor into the shop. Removed motor replace rear seal, swapped narrow front for wide front. After completion drove tractor from shop started losing steering to the right then to the left wheel will turn left and right but tires do not follow I still...
  13. C

    Chat

    Steve thank you for your reply. This tractor was rebuilt 35 years ago has head bolts not stud. When I remove the head everything looked fine there were no signs of leakage anywhere. I was told buy an old mechanic but there is an oil tube that runs from the front to the rear of the motor and...
  14. C

    Chat

    It would have to Been over 35 years ago.for head gasket replacement. And I'm not talking just a skim of oil at the top top of the radiator. It puked quite a bit out the Overflow and there were still quite a bit in the top of the radiator
  15. C

    Chat

    Still no comments on oil tube running through block for oil galleys. If engine sets without coolant in it for a while can these deteriorate and if I do going through a water jacket introduce oil into the coolant I have been told this happens and at that point block is shot
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top