-
Ccircus replied to the thread 92 chev alternator.Got fed up with my 89 Olds going through an alternator every 16 months costing $160 a crack. Finally tore it apart and found there was...
-
CI grew-up farming, my dad had a chunk of rail road rail 1.5 to 2 feet long, that we used for an anvil. Worked good for riveting mower...
-
Ccircus replied to the thread When you need a tall perch.You would think using a second drone to watch the first drone would work just as well.
-
Ccircus replied to the thread Patching a HDPE water tank.Failure, must be contamination or something. Eventually leaks.
-
Ccircus replied to the thread Patching a HDPE water tank.Often there's a lip or edge, you can cut a strip from, on the project your repairing.
-
CTwenty years ago I had a hot air plastic welder, like in the picture, used it twice and it shorted out. Expensive junk. Sprung a leak in...
-
-
Ccircus replied to the thread Anyone re-skin a 1950's shop?.Impressive how little is actually holding the beast up. After 70 years, no arguing it works.
-
-
Ccircus replied to the thread Anyone re-skin a 1950's shop?.I've found, at least when I'm inside, having garage doors on opposite ends allows for a nice breeze. White roof can't hurt. If the...
-
Ccircus replied to the thread Anyone re-skin a 1950's shop?.What plans do you have for the building? It's so big anything beyond patch, prep and paint would cost a fortune with little payback.
-
CHonestly I don't see the need to re-side it. That old Strongbarn is far tougher stuff than whatever you'll replace it with. Paint the...
-
Ccircus replied to the thread Ryobi 40 volt batteries.Got the opposite problem. Bought a snowblower-batteries-charger that I hardly ever use. Looked for more tools to utilize the batteries...
-
Ccircus replied to the thread Ryobi 40 volt batteries.Your lucky, replacement pricing is high because usually your tool is dead. Your tool is still working. Marketing... Years ago each...
-
Ccircus replied to the thread Longest pocket tape measure I have ever seen.Another question is how many tape measures? Once I wasted an hour looking for it, gave up, drove and bought another, used it once and...
-
Ccircus replied to the thread Being stranded and walking home...scooter in the trunk?.This event spurred my interest in E-bikes. Slowly leaning toward bigger and better. The latest one I'm interest in won't even fit in the...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy