-
C
62 2010 ignition switch
Does anyone know the resistance and wattage of the ignition switch resistor- ckwapiti
- Thread
- Replies: 2
- Forum: John Deere
-
C
8n water pump
Just seems odd to have a passage thru the block,gasket and back plate and then plug it with a piece of plastic which they didn't have in 1948]- ckwapiti
- Post #1
- Forum: Ford 9N, 2N & 8N
-
C
8n water pump
The hole shows on all the drawings of the block, back plate and gasket in the parts/ assembly books- ckwapiti
- Post #1
- Forum: Ford 9N, 2N & 8N
-
C
8n water pump
You are correct..however this hole in the back plate is on the suction side of the pomp]- ckwapiti
- Post #1
- Forum: Ford 9N, 2N & 8N
-
C
8n water pump
After 35 years of running my 48 8N I have to change the water pump. After removal discovered a quarter inch hole in the block which penetrates the water jacket and a corresponding hole in the back plate of the water pump, however there is a plastic plug in the hole. I don't understand why it is...- ckwapiti
- Thread
- Replies: 8
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy