-
Ccleddy replied to the thread Water well Pumps.My question is kind of related. I have a farm with a fairly deep well (60 Ft) way up on a hill with a submergable pump. A pressure tank...
-
Ccleddy replied to the thread John Deere H.I hope you got it drained out without turning the engine over. The old guy that had mine got seriously burned when a spark plug caused...
-
Ccleddy replied to the thread 3-jaw chuck assembly instructions needed.Thats exactly how I have done it. Make sure jaws are all the way closed and exactly lined up. A good vice for a press and a big socket...
-
Ccleddy replied to the thread Old coats tire changer HELP.Another big flaw is that 4 ft bar to roll the bead over the rim of the tire has a poor pivot point around the center post of machine...
-
Ccleddy replied to the thread Old coats tire changer HELP.I bought a Coats tire machine just like in the picture but with Air cylinder to break the Bead on top and bottom. It would probably work...
-
Ccleddy replied to the thread Considering a skid steer...thoughts.I don't know how much the JCB with the side door costs compared to regular Skid Steer but that getting On and Off is a big problem with...
-
Ccleddy replied to the thread Grinder Safety Problem.So I put a new 3 conductor grounded cord on the grinder and problem is solved. I did see the black side of the cord went to the motor...
-
Ccleddy replied to the thread Grinder Safety Problem.Lamps are are bad that way because you can usally plug them in either way putting power to outside of socket instead of center of bulb...
-
Ccleddy replied to the thread Missing catalytic converters on a Ford Ranger.Kind of off the subject but will a engine run without a Mass Air flow sensor? I have a 1986 Oldsmobile that I can't get running and blew...
-
CI have a old tool post lathe grinder with a 2 prong - cord and plug. I don't use it much so am sure it not wore out from over use...
-
Ccleddy replied to the thread Trouble light with hook on top that swivels.I been saving ever wire cage that my parents had and I have accumulated in 73 years of my life. I think that adds up to maybe 8-10 but...
-
Ccleddy replied to the thread Spike Tooth Harrow Questions.I can see by the responses the spike tooth Harrow is all but a useless implement from the past??? In my young days back in the 70's we...
-
-
CAnyone have or ever use a drag spike tooth harrow? The one in the pic is from the internet and appears to be green and maybe John...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy