Recent content by clodkicker

  1. C

    12 volt conversion confusion

    I think it is. There is a black "plug" that is covering two connectors.
  2. C

    12 volt conversion confusion

    I am converting from a 6 V to 12 V system on my Farmall M tractor and received the conversion kit -- but the instructions are terrible. I see from Bob M's diagrams references to Terminal 1 and Terminal 2 but have no idea where these are located on the alternator. Help!
  3. C

    Update on Low Oil Pressure on M

    Bearings are brand new--we just overhauled the engine.
  4. C

    Update on Low Oil Pressure on M

    Thanks for all your suggestions that last time I posted. I followed up on them and didn't find any of the problems--no missing plug, oil pump is fine, bearings are correct--still hardly any oil pressure. I believe the problem may be in the rear bearing; when I shoot air through the oil line, a...
  5. C

    Very low oil pressure on new engine

    :shock: :shock:
  6. C

    Very low oil pressure on new engine

    Where did you find the oil pump?
  7. C

    Very low oil pressure on new engine

    Crank was done at the machine shop to .020. I called up YT and told them so they could send the right bearings.
  8. C

    Very low oil pressure on new engine

    Thanks--I'll try this. I got the kit from Yesterday's Tractors and I have to check to see if the plate is worn.
  9. C

    Very low oil pressure on new engine

    Yes, I did have the block dipped. Where would the pipe plug be located exactly.
  10. C

    Very low oil pressure on new engine

    Yes--checked the relief valve--everything is good there. quote="RKM"](quoted from post at 20:10:22 02/03/09) Did you check the relief valve to make sure it is not stuck open?
  11. C

    Very low oil pressure on new engine

    I just finished overhauling our M tractor and replaced the oil pressure gauge (the markings on the old one were not visible); I did not replace the oil pump. The tractor starts but the oil gauge does not move. I took the pressure line off of the oil gauge while the tractor was running and all...
  12. C

    Power Steering for an M Tractor

    I am restoring an M tractor and would like to put power steering on it--does anyone know how I can do this?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top