(800) 853-2651
SHOP NOW

Recent content by col sanders

Yesterday's Tractor Forums
  1. C

    b allis chalmars

    I am trying to get help to time the magneto, had it rebuilt, need to know how to set timing, sorry I screwed,
  2. C

    b allis chalmars

    I have b hand brakes, electric start, good tires, good paint, has magneto,rebuilt, can not get it timed, don't know how. would like to sell. $1,ooo or best offer.gene Watkins 1574-9362603
  3. C

    860 ford tractor

    I have a 860 ford ,that needs two pistons does any one have any/ give me price
  4. C

    timing

    I will pull head tomorrow gene
  5. C

    timing

    I put my finger over the plug hole till it pops that's when rotor stops between 1 and 2 tomorrow I will pull to make sure thanks gene
  6. C

    timing

    the distributor is turning perfect. the rotar stops half way between #1 and#2 when piston is top dead center that is why I think some one has moved the timing gear, is that possible? thanks gene.
  7. C

    timing

    12volt system, 120 all 4 sylinders. plenty of gas,
  8. C

    timing

    I bought a 2n ford with front distributor every thing was missing on the front. coil,points, condencer, cap, solid plug wires, plugs. every time I put to gather, the roter sets between 1 and 2 termenals.looks like some one has had timing gear off is that possible? it has big nut on end
  9. C

    tractor to30

    I need the shaft and trumpet between the clutch and trans . my Sherman trany broke. anybody close to northern Indiana have one thanks Gene
  10. C

    6 t0 12volt 2 wire alt , cked by napa. ac wd45

    2 wire one large, one small. large one goes to the ampgage. where does small one go. need wiring picture if possible.
  11. C

    case 311b

    case 1939 I haven't made up my mind till pull pan of motor. if you want to look at tractor I live Plymouth Indiana ph#5749362603 any time after 6pm. thank you gene
  12. C

    case 311b

    haven't decided yet.depends on how bad motor is when open up. pr0berly. be for sale, I am 84 years young and to other tractors to finish. thanks Gene
  13. C

    case 311b

    I just bought this 311b head off for years sat outside ,not covered, one rear tire and wheel bad, all metal has been in barn and in very good condition. have all parts but two side panels. is there much demand for this tractor?icanot much info. it is round nose. thank gene
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top