-
Remote hydraulics
Ok I’ll look into getting it downloaded. Farmington 👍🏻 I used to live in Brunswick quite a few years back. Great times great people.- Col64
- Post #11
- Forum: Harry Ferguson
-
Remote hydraulics
Hi Jim, I do have a manual but it doesn’t show the picture you uploaded. I did read that it was the up lever once in the remote auxiliary mode but nothing about the draft, so I will have a look at it this weekend. I really appreciate the help and advice. Where are you located in Maine...- Col64
- Post #9
- Forum: Harry Ferguson
-
Remote hydraulics
Hi Jim, Thank you for your answer. I will change my location as suggested. Yes I put all O rings in place and ensured the tube had them fitted too. I have use of the 3 point linkage arms it’s only the remote hydraulics that seem to be the problem. I may remove and re-install as it’s got to be...- Col64
- Post #7
- Forum: Harry Ferguson
-
Remote hydraulics
I got the system from sparpartsholland and there was no instructions, unfortunately ☹️- Col64
- Post #5
- Forum: Harry Ferguson
-
Remote hydraulics
Hi, yes I do the 3 point lifting system runs ok. When I isolate it to use the remote system is when I don’t have any fluid reaching the appliance attached.- Col64
- Post #4
- Forum: Harry Ferguson
-
Remote hydraulics
Hi, I’m after some advice on a remote hydraulic system that I have recently fitted on my MF35. I have hydraulic power to the 3 point system but when I change the lever over to allow the use of the remote system I don’t have any hydraulic pressure or oil in the hoses but I do have oil in the...- Col64
- Thread
- Replies: 10
- Forum: Harry Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy