-
C
1963 JD 1010
You are correct. I pulled the pistons, and there is a soft backup washer and a rubber seal. Those are now on order! I have ordered new rockshaft seals, but im having no luck at all removing the right shaft off the arm. Its probably never been off the shaft. I threaded the bolt back in all the...- Copicatt
- Post #6
- Forum: Tractor & Farm Talk
-
C
1963 JD 1010
Thank you. So am I correct that the fluid should not pass the piston into the bore at all?- Copicatt
- Post #3
- Forum: Tractor & Farm Talk
-
C
1963 JD 1010
1963 JD 1010 Tractor -Gas Been having trouble with bouncing 3 point hitch. Doesn’t bounce while raising or lowering just trying to steady a light load have removed the hydraulic system. I have separated the rock shaft assembly / piston assembly/ front assembly. This is a dual piston assembly...- Copicatt
- Thread
- Replies: 5
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy