(800) 853-2651
SHOP NOW

Recent content by Corning Clunker

Yesterday's Tractor Forums
  1. C

    Dust Collection while Wire Brushing

    I have it blowing across the room, but it is mounted very close to the ceiling, so for the most part it does not blow to much stuff around the shop.
  2. C

    Dust Collection while Wire Brushing

    I know what you mean about Wisconsin Winters! I took an old squirrel cage fan from a furnace, built a box around all but one side that holds 2 each 1" furnace filters and mounted it to my ceiling. it works very well I am amazed how fast those filters get black. Mine is wired to a switch on...
  3. C

    Za hydraulics

    thats kinda what i was afraid of. My neighbors run theirs with wd-45, but that may have a larger reservoir. guess all i can do is try. thanks
  4. C

    Za hydraulics

    I am wondering if my Za has enough pressure/volume to drive a small hydraulic motor on a old bale elevator that i plan on using along with my buzz-saw for firewood. currently the radiator is out of it so i cannot test it, just wondering what you guys think. thanks
  5. C

    Farmall H Pictures!

    Bryce, where are you located, i may be interested in some of those front weights if you have spares, i would think they should fit my M?
  6. C

    Cleaning gas tank on Farmall M

    when i have problem tanks i take them off rig up a bungee cord from one end of the tank to my workbench, dump in a quart of gas and a pound of B.B.s grab a beer and start shaking. repeat a few times and your tank will be good to go.
  7. C

    Electrical Question 8n 6 Volt

    I had similar problems with my 8n, I had replaced points, coil, harness, plugs......... ended up being the coil, I had voltage through the primary windings to the points but the secondary winding that send power to the cap were shot. brand new coil too. i put another new coil on and she...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top