Recent content by Country ave

  1. C

    1086 air conditioner compressor

    Any recommendations for where to purchase a 1086 air conditioning compressor kit for price and quality. I would like to go to the newer style compressor. I would need dryer and mounting bracket.
  2. C

    800 planter

    Can the motor turn but not up to speed, if it is worn?
  3. C

    800 planter

    I went this morning to the salvage yard and picked up a 540 pump. No more spray. I think that I had to much vibration in my 1000 pump. However I could not get over 6 ounces of pressure with any of the three pumps I tried. The oil cooler is definitely clean. Could find no air leaks. I am...
  4. C

    800 planter

    Yes, I am embarrassed did not know about the cooler. However the oil would still squirt out even after a couple minutes of run time. Drum had corn, lid seal and drum seal were tight, saw no other obvious leaks. By the diverter valve, I assume that is the one on the pump, it is screwed tight...
  5. C

    800 planter

    Then is no. 1 detergent oil?
  6. C

    800 planter

    Thanks for your input, I looked for a cooler underneath the shroud could not see one. I assumed the cooler was behind the louvers on the left side and hit the slots with a powerwasher. Went out to plant and it was still blowing oil then the cap came off the pump and dumped most of my oil. Got a...
  7. C

    800 planter

    I have an six row 800 planter that I have used for a few years and generally like it, however, when I shut off the pto the 1000 rpm pump shoots out oil out of the fill cap hole and makes a big mess. If I under fill it I do not get enough pressure. It helps a little to idle the engine before...
  8. C

    1086 oil leak

    Will changing these o-rings or pto gasket require draining the transmission, if that is the problem?
  9. C

    1086 oil leak

    I wondered if the draft torsion bar was able to leak. Didn't know if it had access to the transmission. Is this a common leak on these tractors?
  10. C

    1086 oil leak

    I bought a used 1086 last fall and seems to be a good solid tractor however it is leaking hytran and I cannot find the leak. I thought at first it was leaking out of the hydraulic couplers but am rethinking that every thing is dry above the pto. It congregates on the iron strap that holds up the...
  11. C

    D-17 belt pulley

    I have used a wd pulley with an adapter made by my local welder. He welded a machined shaft for the pulley on a machined round plate with the mounting holes to fit on the drive. I had two made that way.
  12. C

    1086 seat

    I was able to answer my own question. Yes 1460 combine seat cushions fit a 1086. Found a nice set and made a nice replacement.
  13. C

    F-20 brakes

    Put new brake pads in the f-20 a few months ago. They fit tight so I took out the spacers and the cam on the brake shaft set flat. The brakes have dragged ever since. It will go down the road, but not roll down a modest incline I assumed, hoped that they would eventually break in, but are still...
  14. C

    1086 seat

    Can any or all of a 1460 combine seat be transplanted into a 1086 tractor. I realize you would need a left armrest, but if my memory serves me right there is a place for one.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top