(800) 853-2651
SHOP NOW

Recent content by countryboyky

Yesterday's Tractor Forums
  1. C

    The rare 8M

    I wish it was mine lol
  2. C

    Quick update on the 3000

    thats a nice looking trailer...
  3. C

    8N front mount distributor 1950 model

    so no response?
  4. C

    8N front mount distributor 1950 model

    thanks so much for all the help up to this point. now this diagram being crude but it is how my wiring is ran right now. Could someone tell me what goes where, along with what gauge wire to use. I am assuming you mean to get the resistor that you linked for me?
  5. C

    8N front mount distributor 1950 model

    apparently my computer is working in snail mode, it finally let me do link.
  6. C

    8N front mount distributor 1950 model

    there is no work link on my page.
  7. C

    8N front mount distributor 1950 model

    I dont see a link
  8. C

    8N front mount distributor 1950 model

    and no at this time doesnt run as wire from alternator is missing as in burnt off and wires from amp gauge are also fried and missing. some of the other wiring is in bad shape or fried also
  9. C

    8N front mount distributor 1950 model

    from distributor goes to this block and then to ignition side of key, from coil goes to other side of block. alternator wire was fried and went 2" from alternator. I sent you an email Jmor earlier.
  10. C

    8N front mount distributor 1950 model

    Got it with a botched up job on conversion. mine has a wire coming out of distributor and one off the top of the coil. Most drawings I see dont show 2 wires. Any ideas as to where they should run to as he has done a botch job on it.
  11. C

    gonna Start this post with Serial Number

    Some of the wiring has been burnt into or just fried.
  12. C

    gonna Start this post with Serial Number

    In that first pic, is the alternator at an angle as it looks like? And in the bottom pic, where the alternator is attached at the block, is that where the old generator was mounted?
  13. C

    gonna Start this post with Serial Number

    I have acquired an 8N. I know nothing about it other than it is gonna need some work. to start with, wiring was burnt off half of it. Someone tried to convert it to 12V with Single wire alternator. I would like to just replace all the wiring and electrical components, but not sure where to start...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top