(800) 853-2651
SHOP NOW

Recent content by cowboy12

Yesterday's Tractor Forums
  1. C

    JD engine rebuild

    Tractor has been sitting for about 2 + years without running that is known. I put a wrench on the front crank bolt and was able to rotate the crank back and forth approximately 30 to 40 degrees , then it stopped. Not a hard stop and no clanking or grinding. Was told that it could be a rust ring...
  2. C

    JD engine rebuild

    Dated May of 2011
  3. C

    JD engine rebuild

    this is the front cover of the parts cat.
  4. C

    JD engine rebuild

    Thanks Jim.ME . New to this forum and JD. Still figuring out how to use the forum. Didn't mean to post a private message.
  5. C

    JD engine rebuild

    Located above the distributor. Is this the numbers I'm looking for?
  6. C

    JD engine rebuild

    Fortunate enough to get a second 4010 gas barn find. However, JD is totally new to me. Appears that it may need an engine rebuild. How do I obtain the correct information for the engine serial number that I have ? M21HA 224107R . Figuring on an in frame rebuild. Any suggestions as to a supplier?
  7. C

    JD 4010 pto ?

    True part # of AR28572. Appears to be original part. Hole depth of approximately 5/8 inch.
  8. C

    JD 4010 pto ?

    A big THANK YOU to wore out
  9. C

    JD 4010 pto ?

    I currently have a six spline stub with a center hole. Accordingly, that would allow 1000 rpm. I will thus mill a corresponding pin to be placed into the hole, thereby depressing the pin. Anyone see any potential problems in doing this?
  10. C

    JD 4010 pto ?

    New to John Deere restoration; Recently purchased a 4010 gas, stub pto was broken off. Have to extract the four bolts. Question 1. How long are the bolts that hold the stub on? Question 2. The center pin ( 540 / 1000 rpm ) needs to be in or out for 540 rpm? The reason I ask.... I have seen...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top