Recent content by cowman79

  1. C

    2955 4wd will only move in four wheel drive

    It looks like you are correct about the key. I started to look at pulling the wheels and noticed that the left side was in a different location on the axle shaft than the right. It appears my wedge with the key had come loose and the key has been worn off the wedge. This is a much easier fix...
  2. C

    2955 4wd will only move in four wheel drive

    I had the tractor up on jack stands tonight and I locked the differential and I could not see a difference between the right or left wheels pulling when holding the brake. Both wheels tried to turn but there was some grinding/ rubbing noise coming from the rear end. The noise seemed to come...
  3. C

    2955 4wd will only move in four wheel drive

    The wheels turn when it moves but the tractor won't pull itself up a hill unless the front wheels are engaged.
  4. C

    2955 4wd will only move in four wheel drive

    I never tried engaging the differential lock. The tractor will pull itself on flat ground without the front wheels engaged but any type of a hill it will quit pulling. I drove the tractor to the shop and don't plan on moving it until it goes in the shop to be tore apart. I am planning on taking...
  5. C

    2955 4wd will only move in four wheel drive

    I noticed the other day that my tractor seemed to be lunging forward a few feet when going down hill. Today I started to turn up hill and the rear tires started to pull and then quit pulling. I was able to engage the front wheels and the tractor would start moving. I am thinking there is...
  6. C

    2955 loose fuses

    I am actually looking for the connectors that go on the wires that plug into that piece.
  7. C

    2955 loose fuses

    Is it possible to replace the fuse holders in a 2955 fuse block. These is an open station tractor. I am in the process of rewiring all of the fender lights and have a few fuse holders that won't hold the fuse tight all of the time. I know you can buy the holders and replace them. But I don't...
  8. C

    Trouble removing block heater on 2955

    I went back to it today and it came out. Maybe the kano worked its magic. The interesting thing is the element was completely gone. It looked as if it was twisted off. But it was nowhere to be found on the inside.
  9. C

    Trouble removing block heater on 2955

    So I decided to bring the 2955 in the shop and perform some maintenance. I am flushing the radiator, rebuilding the water pump and replacing a bad block heater. I was able to get the small nut on the block heater off but when I try to remove the large nut to be able to remove the block heater...
  10. C

    Farmall m with hand clutch needs brakes

    That makes me feel better about taking it apart.
  11. C

    Farmall m with hand clutch needs brakes

    I have an m with a m&w hand clutch that needs brakes Is there anything special I need to be aware of when I start to take this assembly apart.
  12. C

    2955 steering return filter leak

    I do have a manual. The only pressures I have tested previously are the charge pressure and the pressure coming out of the SCV.
  13. C

    2955 steering return filter leak

    I don't think the filter was plugged, I blew thru it and it was free. What pressure do I need to check. The high pressure. Or the low pressure.
  14. C

    2955 steering return filter leak

    Mine was hot at the time. I had been mowing for a couple of hours. The filter had a split in the seam where it was assembled.
  15. C

    2955 steering return filter leak

    I was getting ready to remove my disc mower today and the steering return filter started spraying hydraulic fluid. Is it possible that this filter just sprung a leak or should I be looking for some other problem.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top