(800) 853-2651
SHOP NOW

Recent content by Craig Cherry

Yesterday's Tractor Forums
  1. C

    IH 2444 oil filter and governor questions

    Does this mean that I don't use the 6" from the top on the plug next to the shifter as my level for hydraulics?
  2. C

    IH 2444 oil filter and governor questions

    The filter I am asking about is the engine oil filter housing. As it sits the filter housing hold down bolt passes through the center of the filter and pushes the housing cover against the o ring. I will be ordering another filter and when I get that I can take it apart and get some pictures...
  3. C

    IH 2444 oil filter and governor questions

    The loader is a Freeman 2000 if that helps. I was afraid that I would have to pull the hydraulic pump to get at the seal, but I needed confirmation before I would just jump into it. Thank you for the help. I guess I just have to bite my lip and dig in. Or I may just go ahead and sell it and let...
  4. C

    IH 2444 oil filter and governor questions

    Is there supposed to be a spring and stopper inside with the filter inside the housing? Mine has a serial number of 00838 and is an inverted filter. I have been running into an issue with the hydraulic fluid getting milky and also seems to be getting into the crank case. It has a loader...
  5. C

    IH 2444

    Ok I guess I get it. The trans level doesn't matter as long as the reservoir under the seat is at the correct level. I'm just not used to seeing a trans with no visable fluid level in it. So is there a screen or something that could be plugged causing my power steering to quickly start...
  6. C

    IH 2444

    So what is the level in the transmission supposed to be? It looks to me that the power steering pump pulls from by the trans or am I wrong? By the way my manuals are on the way, but I"m trying to get this thing ready for firewood this weekend. Thanks
  7. C

    IH 2444

    Thanks for the replies guys. So.... from what I'm understanding, the trans level should be up to the bottom of the plug hole next to the shift lever?
  8. C

    IH 2444

    Recently sold my MH33 and purchased a IH 2444 S/N 00838. It seems to be a perfect tractor for small field work, firewood and trail maint. After only a couple of hours of operation the power steering is making a lot of noise while turning and has stuttering resistance. I don't see any fluid...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top