(800) 853-2651
SHOP NOW

Recent content by craigco

Yesterday's Tractor Forums
  1. C

    Under ground water line.

    You can get a leak detector. Basically a big stethoscope and you listen for the water/bubbles. If you can hook an air compressor to it you can really here the bubbles. There are companies that will do it as well. My buddy bought one off Amazon for not a lot. Found the leak within 3 inches of...
  2. C

    1952 john deere a questions ??

    Most have pipe plugs in them. On my late B had to get brass valves installed so the starter could turn it over with higher compression. I think they were just 1/8inch valves. Might be larger on an A.
  3. C

    Frost-free hydrants

    Make sure you install a valve so you can shut the water off near the hydrant then you dont have to turn off the entire system to do maintenance on the hydrant. When you buy the hydrant get the rebuild kit at the same time and put it on the shelf. Depending on the hydrant mostly Chinese made...
  4. C

    Oddest place you’ve driven farm equipment

    Drove across the Royal Gorge Bridge. Highest suspension bridge in US.
  5. C

    John deere 3010 injection pump timing issue

    I have 3 diesel 3010s. 1 has the updated pump and 2 have original. I have an picture of an original. Basically round with a rectangle on the side to the rear of the tractor. Updated pump has an extra round bump on the front side of the pump. I had similar trouble setting a pump once. Took...
  6. C

    PICTURE of 1964 JD 3020 gas w/powershift: Trans-Disconnect Lever mechanism

    My friend has a 3020 utility gas poweshift. Both levers on the left side.
  7. C

    Massey 1105 hasnt run in 20 plus yrs

    From the research I have done the Perkins used not so good oil rings. My 1105 smokes while sitting at idle. Goes away once you start working it but comes back when you throttle down. Not fuel, rebuilt pump by dieseltech. Tried seafoam didn't change any thing. Its starts at 14 degrees in about 4...
  8. C

    Hooking up a gooseneck to a crew cab pickup

    I put a cheap back up camera in the bed that displays through the rear view mirror. Wired to the reverse lights. Before that I could lay down the back seat a just barely see the ball.
  9. C

    3020 clutch

    I got the assembled clutch from ft Wayne clutch . I think it was $800 or so when I did mine. Could be cheaper to rebuild all off it but I usually have to weigh the cost vs time down. It came with everything including the alignment tool. Pack the old one up and UPS picks it up for the core.
  10. C

    Advice on seeding down

    Its a cover crop get it cut off sooner so it doesnt smother the hay.
  11. C

    3010 LP shut-off valves

    TSARE9101P5 Part number for tank valve. You will need different rod adapters from Abeline machine.
  12. C

    3010 LP shut-off valves

    Abilene machine has new valves and adapters for the rods. I ordered one for the vapor side. Hold on they were pricey. But the valve is a standard gas valve they left the part number on. It's about $25, if you by the valve from a different supplier. You will have to by the adapters to attach the...
  13. C

    Stanadyne Roosa Master Injection Pump

    I agree contact dieseltech. He has rebuilt 4 for me and probably 4 friends I referred. As long as the shaft isn't broken the cost is very reasonable.
  14. C

    730 LP converter (vaporizer) leaking coolant

    My local propane dealer had the kit to rebuild one on a 3010. Try to find a dealer that has been around a long time. You also might try a forklift dealer repair shop.
  15. C

    JD 3010 reinstalling engine.

    The pto clutch disk floats in the pressure plate. When you pull the alignment tool out it will drop down. You should be able to push it back up from underneath. Double check alignment of traction disk.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top