-
C
YM2000 3 point lift
There is a hydraulic line that is plumbed from the loader control valve into the side of oil fill/dipstick boss. What would it's purpose be other than a dump for the loader pressure relief? If you operate the loader with the 3 point raised, the 3 point will lower.- crawfish-HT
- Post #1
- Forum: Yanmar
-
C
YM2000 3 point lift
If I raise the 3 point, close the lockout valve, and the 3 point stays up, will that narrow down the problem? I've read on this site that you shouldn't close the lockout valve with the engine running as it can/will cause damage to the hyd pump. Does the front end loader control valve have a...- crawfish-HT
- Post #1
- Forum: Yanmar
-
C
YM2000 3 point lift
The lift won't hold when you kill the tractor. Heck, it won't even hold when the tractor is running. After it starts getting "weak" I can put the control in the raise position and the bush hog won't move. With the engine running if I physically lift the bush hog, it will raise, but as soon as I...- crawfish-HT
- Post #1
- Forum: Yanmar
-
C
YM2000 Head Gasket Retorque
After replacing the head gasket, should the head bolts be retorqued after a certain number of hours?- crawfish-HT
- Thread
- Replies: 2
- Forum: Yanmar
-
C
YM2000 3 point lift
I'm working on a YM2000 with a bush hog and a Bulldog front end loader. The 3 point lift will raise the bush hog for about 3-5 minutes after the tractor is started, then it get progressively "weaker" and gets to the point that it wont lift it at all. The front end loader works fine all the time...- crawfish-HT
- Thread
- Replies: 8
- Forum: Yanmar
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy