Recent content by crazytractor

  1. C

    D8 13A PONY TROUBLE

    I have several service books but not sure if it has all info. My concern is. If it start quick and ran great for a while Why would it be out of time? It only started backfiring after a short while of running, And the it started the backfires. Can low or empty fuel cause this too...
  2. C

    D8 13A PONY TROUBLE

    Well i finially got the pony runing , well momentarily. I replaced the spark pulgs, and condenser, and polished the rotor and points. And started after a few tries. it started loud, but very strong and smooth. I got to turrining the enging, and after about two minutes it started back firing...
  3. C

    D8 13a Caterpillar Bulldozer Pony trouble

    Well I dont think the timming is wrong as it has not been removed at all.. but i will still check the time to make sure its right. the carb is simple and have gone thru it twice, but im sure that the carb is good. As per the spark, i hava a cheap spark tester, and frankly i see the spark light...
  4. C

    D8 13a Caterpillar Bulldozer Pony trouble

    Well it had been sitting for a few years so i should change the oil, but im not sure why the timing would be out, i didnt move that. And it was wirking good last time it ran.
  5. C

    D8 13a Caterpillar Bulldozer Pony trouble

    Im no expert but mechaniclly inclined. This pony is cracking my head. I cleaned the carb twice. Loosened stuck valves that were stuck open Therefore had no compression. Had no spark from the magneto and got that working. I crank the pony and dont get any puffs from it. I even squirted gas down...
  6. C

    D8 13a Caterpillar Bulldozer pony compression trouble

    finally got the compressions issue resolved. I removed the front plate cover like recommened and there it was .. the two middle vales were stuck open. a little bit od penetrant and a slight tap and got one loose, the other one took a littl emore effort. but got it loose. now again my carb...
  7. C

    D8 13a Caterpillar Bulldozer pony compression trouble

    I have tried skirting oil down the plugs. But i didnt put that much of a thick oil, and it didnt do any difference. Before i stopedd it last time. It had good compression, so i am thinking there a valve stuck open. Untitled URL Link
  8. C

    D8 13a Caterpillar Bulldozer pony compression trouble

    I have been having trouble with getting the D8 13A running. Pont yrouble at this time. Was having spark trouble, fixed it,, then carb trouble and fxed that. Now I have no compression on the pony when i crank it I cranks with the starter, but like i say vary little compression. does any one...
  9. C

    1953 Caterpillar D813A trouble

    Today i tried the inner tube trick but failed on me as i didnt have a big enough clamp to connect the inner tube to the external gas tank that i installed temporary to try sny start the tractor, i also have very little compression on the pony motor so i think that the piston rings were dry or...
  10. C

    1953 Caterpillar D813A trouble

    Currently im at the point where i have installed an external tank to make sure fuel is clean and know there is no obstruction between tank and filter housing, i will try the air trick. The mag i finally got going again and fully cleaned the carb on the pony, will go install today ans see what...
  11. C

    1953 Caterpillar D813A trouble

    Will the tube trick work with the engine off ? Will the fuel flow thru the diesel pump too and all the way to the injectors end at the heads?? Untitled URL Link
  12. C

    1953 Caterpillar D813A trouble

    Troube starting my old D8 project, I used to be able to start the pony and start big 6 engine for about 5 minuts and then shut off by sucking all the fuel back to the tank out of the filter housing. That was a few years back, Now im having trouble getting spark at magnet and fuel in carb. Is...
  13. C

    International T9 LP Crawler info wanted

    I have this old LP T9 that my dad obtained years ago. I havent ran it in a while, bit the steering is having trouble. One side has a bad brake and the other has a froze clutch. if anyone knows the year and if there are parts, where I can buy the parts, and pictures f possible, You can log in to...
  14. C

    T9 LP INTERNATIONAL CRAWLER

    This crawler was purchased in the 70s by my dad and i think previosly being used in orange groves, it had a big steel pipe home made attachment that extended about 7-7feet from tractor and super heavy so we took it off and created somting light. As per lp i been looking for others to see...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top