(800) 853-2651
SHOP NOW

Recent content by Dan from WI

Yesterday's Tractor Forums
  1. D

    8N front mount electronic ignition conversion kit?

    Looking at the kits available for a front mount 12 volt negative ground electronic ignition conversion, the photo with the item for sale shows a regular round coil and a coil wire. Is that the way they come? Thanks!
  2. D

    Well, that didn't go.........

    After going through my carb and distributor I discovered that my 48 would only start with the throttle off and the choke open. Anything more and it floods. Pops off every time at slow idle and takes a few seconds to catch and allow the rpms to be advanced. Good Luck!
  3. D

    Pokin' fun at my new project tractor (pics)

    Whoever drove that thing must have taped 40 grit sand paper to the sole of his shoe to wear that clutch pedal down like that.
  4. D

    8n in Washburn, WI

    http://duluth.craigslist.org/grd/4892410666.html Don't know the owner, sounds overpriced to me.
  5. D

    Another Hitch Question

    Here's the picture
  6. D

    Another Hitch Question

    I'm not sure what the plate attached to the bottom end is for. It's attached with two bolts.
  7. D

    Roy Rogers Equipment

    Gene, the hood on the Cat was about the same height as the 9N. Small machine with no loader, just the crawler.
  8. D

    Roy Rogers Equipment

    The Episode I watched had some cattle rustlers who were stealing young livestock and hauling them away in a pickup.
  9. D

    Roy Rogers Equipment

    Sitting here with the flu, bored out of my tree watching Roy Rogers yesterday and what to my eyes appears but a Caterpillar Crawler and what appeared to be a 9N. Anybody else been checking out Roy and Dale's equipment. I wouldn't mind having a jeep like Nellybell around either.
  10. D

    Project Tractor? (pics)

    That's too bad, I don't know that I would want to tackle that job. Can't be worth anything more than scrap price I would think.
  11. D

    Ford N Series & The Handshake That Changed Farming Forev

    Great Article, Thanks for sharing it here.
  12. D

    How to drive a 2 well point 80'.

    When I was on our local Fire department we drove in 110 climbing poles at the lumberjack bowl using 1 1/2" pipes attached to a pumper. Those big poles sank right in and are still there today. I like the idea of the borzit and would think a pressure washer could provide enough ummph to sink a 2"...
  13. D

    today's funny

    30 below and no wind in NW Wisconsin this morning, Think I might dig out the long johns...
  14. D

    LOOK at THIS truck!

    There's one like that up here only the setup is for the driver. The owner rolls his chair right into the opening, lifts up and then slides in behind the wheel. Pretty slick and really enhances the guy's mobility
  15. D

    HOLY #$%@#!

    That dude is one bad turn away from rolling and killing himself. It's impressive but idiotic to drive it like that.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top