(800) 853-2651
SHOP NOW

Recent content by Dan Rayl

Yesterday's Tractor Forums
  1. D

    U heads

    Kef engines had one piece heads. I've had two mid 1940s U's with that engine.
  2. D

    G900 water pump

    Jeff, it took 30 seconds after I found the 5th bolt. Thanks, Dan
  3. D

    G900 water pump

    I'll check it out. It makes sense there is another. There is five holes in the gaskets
  4. D

    G900 water pump

    I normally can figure these things out, but I can't seem to get the water pump off the tractor. I have taken out the 4 bolts and disconnected the hoses. It's loose but acts like there is still a bolt I'm not seeing. Any help would be appreciated.
  5. D

    Maybe it is just me.

    I saw this tractor before he tore it apart, looked to be decent shape! He about 1/2 hr away from me. Parting out these old tractors isnt illegal, but it may be immoral in my opinion.
  6. D

    Block heater cord

    -13 degrees this morning, didn"t attempt to start her up! Thanks for replies!!
  7. D

    Block heater cord

    Anyone know where I can locate a couple cords for the engine block heaters on a G900?
  8. D

    335 transmission/clutch problem

    I had the same problem with my jet star3. Its was the plates in the torque, sheared all the ears off. You have to split the tractor to get at it.
  9. D

    MM Minneapolis Moline cab

    I have a femco cab off a G900 row crop that I would like sell or trade. It is in great shape! All the glass is good. I have no need for it. I"m in Michigan.
  10. D

    G705 pics and also a question

    Your right about not fitting. The cab I have is for a row crop tractor. I must of had a brain lapse!
  11. D

    G705 pics and also a question

    I have a cab off a G900 that fits in between the fenders. I"m not positive it will fit. It is 42.5 inches wide.
  12. D

    Need radiator in Texas but I live in Michigan.

    I am new to this forum stuff. I try that, thanks!
  13. D

    Need radiator in Texas but I live in Michigan.

    I bought a radiator for my Minneapolis Moline in Glen Rose, Texas. I lived in Michigan. It is paid for and on a pallet. If anyone is passing through texas and heading near Michigan, I would appreciate some assistance. cell #989-550-313 1. Thanks, Dan
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top