(800) 853-2651
SHOP NOW

Recent content by Dana Norby

Yesterday's Tractor Forums
  1. D

    Todays funny

  2. D

    hitch assemble for a 1945 john-deere b

    Where are you located? I may have a frame.
  3. D

    JD 2510 diesel engine

    I did like ET said and had a machine shop bore out the bottom and press in rings with oring grooves on all 4 holes. Happy with everything except the price. 😀
  4. D

    BackHoe Model

    Used to have one like that without the Deere decal. Made by Bradco in Manchester Iowa. Had gotten parts from factory in the past.
  5. D

    70D pony motor starving for fuel.

    I have a 70D also. The fitting on the bottom of the tank is actually a little below the inlet of the carburetor, so I have to run off the top half of the tank.
  6. D

    Is a 2008 John Deere 310SJ a reliable machine?

    I have one that I bought used several years ago that has 4X4, extend-a-hoe, pilot controls on hoe, 4in1 bucket on front. I love it and it does more than I should ask of it. Other than fixing a transmission seal that leaked externally, all I have done to it is service and replace two hoses that...
  7. D

    JD 2510 diesel engine

    Light pitting around all holes with two of them having an eroded chip out of edge against water maybe 1/4” wide and 1/8” back away from flange. Could try to get pics later.
  8. D

    JD 2510 diesel engine

    Not blaming anyone, was a farmer OH and then restored. Weighing salvaging block and making use of new sleeves and pistons vs. finding replacement drop in and potentially buying the same or different problem.
  9. D

    JD 2510 diesel engine

    Have a 2510 diesel with less than 200 hours on overhaul (before I purchased) that now lost antifreeze into oil past the orings. There is erosion in block where orings seat, so need to make some choices. Don’t know if block can be repaired at what cost, find replacement engine, or?? Original is...
  10. D

    Steering wheel

    JD tractor, shiny coating is mostly gone off of my steering wheel and I get black all over my hands. Is there anything I can do or do I need to replace? Thanks
  11. D

    JD A Spacer Bolts

    Sorry, not interested in splitting up the kit.
  12. D

    JD A Spacer Bolts

    I have a set with spacers.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top