-
D
Hole in block
after looking closer, it mayleaked around the top between block & sleeve. Hard to tell. The hole start about 2in. from top between #2 and valve side- dandbald
- Post #1
- Forum: Tractor & Farm Talk
-
D
Hole in block
bought it at an auction. #3 cylinder had signs of water damage "rusted up". Sleeve was worn quite a bit. Appears to have a blown head gasket.- dandbald
- Post #1
- Forum: Tractor & Farm Talk
-
D
Hole in block
I'm new at this so be gentle. Pulled sleeve on #3 cylinder and found a 1"x2" hole in the block wall. Will putting a new sleeve in, fix it?- dandbald
- Thread
- Replies: 9
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy