-
D
ATTENTION: Mid Ohio Tractor Pullers
ATTENTION: Pull for August 29 has been resceduled for September 12. Please let your fellow pullers know. Thanks- DandK
- Thread
- Replies: 0
- Forum: Tractor Pulling
-
D
010 av Sthill saw
Hole is for the tank vent. Line thru hole with grub screw inside the line. Line goes out hole in rf of the air box (under fuel fitting of the carb) if no hole there it is an early model. Drill one. Sheet meta screw in end of the line to keep dirt out. -
D
Need wheelie bars and front weight bracket...where can I buy
I do wheelie bars but not weight bracket. Call if interested. 419-230-4297 Duane- DandK
- Post #1
- Forum: Tractor Pulling
-
D
Motpa pull today cancelled
MOTPA pull today at Midway Oh cancelled.- DandK
- Thread
- Replies: 0
- Forum: Tractor Pulling
-
D
GOOD DAY
Glad we made the trip from Ohio. Had a good time. We will be back if our scedule permits.- DandK
- Post #1
- Forum: Tractor Pulling
-
D
OSATPA
Jan 2013. OSATPA winter meeting. Open to all members. A rule change was proposed, discussed, voted on in two consecutive meetings,a month apart, and passed. Rule was to allow 310"s, 450 blocks, aftermarket Deere blocks, 800"s, gleaners and yes, RD,s. The members in attendance agreed that these...- DandK
- Post #1
- Forum: Tractor Pulling
-
D
Needing wheelie bars
Give me a call. Super M no problem. Dont know Case axle housing size. 419-230-4297 Duane- DandK
- Post #1
- Forum: Tractor Pulling
-
D
Homelite Super 2 chain saw - how does enginie split ?
Case splits at the crankshaft. Four bolts i think. Crank rod and piston then can be pulled from cylinder. That is a chrome cylinder, dont try to hone it. If it is clean, put in new ring and reassemble. If galled, scored or built up with aluminum from the piston clean with fine sand paper in a... -
D
pics of wheel centers with cutouts
This tractor pulls 4500 to 8500 as seen in the pic. It is not plowing on a hillside. Dont cut into the stiffner ring near the wheel weight holes and it will be fine. Make sure your cuts are smooth with a good radius to keep them from cracking. Duane in Ohio- DandK
- Post #1
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy