Recent content by DanHoman

  1. D

    H Farmall

    Okay, I posted a couple of pictures on the Gallery under 1948 Farmall H. The rim on each side appears to be a rim welded to two rims, but it is all factory original. I am a little confused because several people are telling me several different things about this tractor. I have always been a...
  2. D

    H Farmall

    I was recently given an "H" Farmall by my best friend from out in Oklahoma. The serial number is FBH 284564 X1. This tractor had narrow dual tires mounted on each rear rim. The rim is one piece, but has to 7-40 tires mounted on it. ALSO a guy I talked to said the "X1" in the serial number...
  3. D

    H4 Farmall Magneto Rotor drive

    Follow-up on the H4 magneto. I crank it over holding the coil wire next to the engine block and get a continuous nice blue spark from the coil wire. It will jump approximately 3/16 to 1/4 inch.
  4. D

    H4 Farmall Magneto Rotor drive

    I was recently given an "H" Farmall. According to the serial numbers I checked this site and discovered it was manufactured in 1948. (using this site for my information) I checked the spark, and I am getting intermittant spark. The rotor (inside the mag) is loose and wobbly on the metal shaft...
  5. D

    H4 Farmall Magneto Rotor drive

    I was recently given an "H" Farmall. According to the serial numbers I checked this site and discovered it was manufactured in 1948. (using this site for my information) I checked the spark, and I am getting intermittant spark. The rotor (inside the mag) is loose and wobbly on the metal shaft...
  6. D

    Fines for using red diesel in a haywagon

    I think there might be a misunderstanding on who and what. It probably wasn't an "I.R.S." agent who came visiting. It was more like the state P.U.C. or D.O.T. tax/revemue department. (different states go by different department names, like P.S.C., etc, etc.) Trust me, they are the kind who...
  7. D

    Question How to ADJUST oil pressure John Deere A

    Thanks I appreciate that... In order to keep from trial and error about how much should I turn the adjustment to get about 20 to 25 pounds, if it is only showing 10 pounds now?
  8. D

    Question How to ADJUST oil pressure John Deere A

    I have a 1946 A John Deere. I just had new rings, reground crankshaft, rod bearings etc... In this tractor. According to the gauge at full throttle the oil pressure is only 10 lbs. I prefer it to be a little higher, because I intent to install an oil pressure shutdown switch in the pressure...
  9. D

    Unusual tires on Farmall (DOES ANYONE KNOW)

    I am in Tennessee, My friend lives near Kingston OK.
  10. D

    Unusual tires on Farmall (DOES ANYONE KNOW)

    Hey folks thanks a bunch for the comments and information. I couldn't find anyone who knew what the tires were. I knew I had never seen the dual setup with BOTH tires mounted on the same rim. Thanks again.
  11. D

    Unusual tires on Farmall (DOES ANYONE KNOW)

    My friend in Oklahoma just bought an "H" Farmall with unusual tires on the rear. This Farmall has "DUAL" tires, BUT ON A SINGLE RIM. Each rear wheel has TWO tires on it. I have never seen two tires on a single rim, and he says it is factory. He also says this tractor doesn't have hydraulics...
  12. D

    John Deere A rod bearings

    I have a 1946 production "A" tricycle John Deere. Recently I took it down the road and it began knocking when engine was slack. Couldn't hear it when it was pulling. I know my old un-styled B had babbit rods, but I don't know if the A has inserted rod bearings or babbit. Does anyone know for...
  13. D

    No traction on ice

    Mack trucks used to have what they called a "limited slip" differential. It allowed one side to slip about 1/8th of a turn before the opposite side began pulling. They worked great, and you just about couldn"t get one of those old Macks stuck. Check some truck salvage yards and see if there"s...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top