Recent content by Darin Johns

  1. D

    2255 or g1355 vs 1566

    The 2255 is way lighter just at a pull 2255 in 12700 had weights on it that old 1566 will smoke them both put together
  2. D

    806 brakes

    Take the drum off has shims behind it you can remove to tighten it up
  3. D

    international 986

    The mcv lost its prime it's on left side of ta housing there is a plug on back side towards rear end of tractor is close to bottom of mcv housing takes a 5/8 wrench take out start tractor oil should spray out replace plug should be good to go
  4. D

    1456 slow starter

    Injectors and pump
  5. D

    Planter again.

    The cyclo is ten times the planter of the Deere . The spacing is not as good but the seed to soil contact and even depth can't be beat a Deere is like throwing you seed out by hand and hoping it grows
  6. D

    Farmall 450 C-281 Maximum Bore Size

    I run a m with 281 block with 4.36 bore 306 CID still has sleeves run a grinder every day to feed cattle.got those from Denny's carb shop. Murphy's motor can help to
  7. D

    chewy

    It's just not burning the fuel that's why it cleans up when you run it hard
  8. D

    Is my block done for?

    Block is fine you might just have to have a machine shop bore and re sleeve that broke one
  9. D

    4630 fuel pump timing

    You need the john Deere tool goes in back right side of bell housing locks flywheel back behind the breather hose they make a tool to spin motor to good luck gotta love green
  10. D

    MTA

    Check with ag parts I think you can buy one way cheaper then that
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top