(800) 853-2651
SHOP NOW

Recent content by Dave N NC

Yesterday's Tractor Forums
  1. D

    John Deere 550 ether damage

    If it still cranks hard and blows a lot of black smoke you could have a head gasket blown between the cyls.
  2. D

    Cockshutt 570 motor bolt pattern

    No the 570 is a Hercules the 50 is a Buda.But I have a 50 with a 3400 Hercules need to use 570 back plate flywheel pressure plate with a 50 clutch disc and a 570 clutch cover. also have to redrill mounting holes in frame. exhaust on other side
  3. D

    Liebherr 932 Excavator One track runs slow

    pull the plate off under the cab look where the travel levers are connected either a linkage or cable and the pilot valve will be on the other end. this is a small valve that directs pilot oil to the main control valve. and the pilot oil moves the main control spool in realation to the pilot...
  4. D

    Liebherr 932 Excavator One track runs slow

    I just worked on a PC-220 and found that the piolt control valve was not going as far as the other one make sure that it has full travel
  5. D

    bearings ( main)

    Are you sure you did not put the main caps on backwards
  6. D

    manhole cover thief caught !!!

    Some people decided it would be easy mony to steal radaitors from a heavy equipment parts yard druk several out of the yard they are heavy but the joke was on them Cat radaitors are all steel .08 cent a LB.
  7. D

    6000 Commander injection pump

    Are you sure that #1 cyl. is TDC on compression stroke? both valves on #1 cyl should be loose. If it is 180 off try turning the engine 360 and see if marks line up.
  8. D

    hitachi 120 swing motor seal

    grease will not give your swing brake discs the lube they need
  9. D

    Removing Link in Track Chain

    You have to have a torch first drive out the master pin then take the pad off of the link you want to remove then cut the bushing out and cut the pin in 2 slide the cut link off then you will see that the next links bushing is prodruding out on each side maybe 1/2 inch cut the produdingpart of...
  10. D

    Allis 5040 - hard starting after running

    I didnt catch the slow cranking speed problem. a diesel needs to turn over aprox 500 rpms to fire. a dragging starter will turn slower when hot than cold. Are your cables getting warm if so the starter is pulling to many amps. I would have the starter checked out
  11. D

    1988 Cat 935C Loader w/ 4:1 Bucket

    I agree with bob most likeiy out ot adjustment or linkage come apart.I have had them with the brake band lining wore out or come off the band. I live in the Charlotte area can repair it for you if it is moer than you want to handle Iam mobile and can do it on site. Dave [email protected]
  12. D

    1988 Cat 935C Loader w/ 4:1 Bucket

    I agree with bob most likeiy out ot adjustment or linkage come apart.I have had them with the brake band lining wore out or come off the band. I live in the Charlotte area can repair it for you if it is moer than you want to handle Iam mobile and can do it on site. Dave [email protected]
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top