-
DDaveBN replied to the thread Disk Blades.Advertise them for sale. If you get a buyer then take them off. Dave
-
DDaveBN replied to the thread Farmall A receipt.My best guess at reading that receipt is: 1 Farmall A tractor. $589.50 1 synthetic 9-24 tires. $28.20 1...
-
DDaveBN replied to the thread Farmall A receipt.Very interesting receipt. I thought swinging drawbar was standard equipment not extra charge. Same for the muffler. Notice the spelling...
-
DDaveBN replied to the thread Tough weed.Can you post a picture of your weed please. And your location. Dave
-
DDaveBN replied to the thread Rhythmic bumps while moving.I'd try tightening ALL the lug nuts and bolts. I fixed a Farmall last weekend by doing that. Dave.
-
DDaveBN replied to the thread Another cub 154 low boy question.Tip: when I have to cut off a bolt I put a nut on far enough to be out of the way of the cut. Then cut the bolt. Then when you take off...
-
DDaveBN replied to the thread SW Michigan Fly Wheelers show 10th-13th.I am going on Friday. I go every year. Dave
-
DDaveBN replied to the thread Farmall 140 front mount blade question..You'll need to get a manual for the push plow. I believe you use most of the same parts for front mount and belly mount. I believe the...
-
DDaveBN replied to the thread New Avery update.Another week and it should be running! Dave
-
DDaveBN replied to the thread Best way to cut lead.What ever you use spray the cutting area with WD-40. Then the lead won't stick to the cutter as it melts from the heat of being cut. Dave
-
DDaveBN replied to the thread Oil volume, dipstick or manual?.Are you sure you have the correct/original dipstick? Dave
-
DDaveBN replied to the thread Tie rods for Allis Chalmers D14.The new tie rod ends must be VERY stiff. Maybe try beating them to liquify the grease or drill and tap a jerk fitting and shoot some new...
-
DDaveBN replied to the thread Hey Grandpa…..I am a grandpa but not the one your looking for. I can tell you though that those tanks are hard to clean. There is a baffle at the rear...
-
DDaveBN replied to the thread Farmall C Carburetor.Did you check the parts section of this site? They show several kits as well as new and rebuilt carbs. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy