(800) 853-2651
SHOP NOW

Recent content by daveminn

Yesterday's Tractor Forums
  1. D

    pressure regulator valve question

    Just put a new charge pump on my 850 c case crawler because I was having problems with the oil in my torque heating up after a half hour of pushing.Problem solved with the temp but the pressur valve still wants to run high and kick oil out of the torque after a half hour or so of use.My service...
  2. D

    exhaust heat temp guage and air cleaner guage

    Case guys,need advice : case 4690 exhaust temp guage always runs in the highest red area when pulling the fieldcultivator!What should I look at to get it down in the green again?Also changed both air cleaner filters and the lite comes on every time it pulls hard.even tries taking the filters...
  3. D

    Case 850-C Dozer Transmission Fluid?

    My 850 c does the same thing heats up after 20 min. or so and leaves a trail of oil on the ground until it dosent want to move till it cools down and ii add more oil to the transmission.Found out this last winter from a person who fixed his that was doing the same thing that you need a new...
  4. D

    need photo on what drives the hdy pump on a 500 standard

    Can someone post a photo of a hdy pump and how it is driven on a 500 diesel standard tractor?My books don't show what drives it and am putting one on my 500that only has a smooth shaft coming from the other housing.Thanks so much for any help you can give!!Dave A
  5. D

    500 case standard starter sellenoid att.john s

    John,Cant seem to find a selinoid for a 6 cylinder 500 standard tractor,can you help?Dave A
  6. D

    500 case been sitting,need advice

    Starter is bad so will need to pull to get it to our shop.If I take the injecter off,how do you time it to get it back on?Da
  7. D

    500 case been sitting,need advice

    need advice on starting my 500 case diesel that has been in the shed 3 yrs?Concerned about that injection pump,so I don't do any damage as I am planning on pulling it to start.Any help is very much appreciated!!Dave A
  8. D

    D6 9U engine service book and tractor book

    the engine has these #'s D318 industrial D318 Electris set D318 Marine No 12 motor grader No 6 traxcavator No 977 Traxcavator D6 tractor Dw10 tractor Written on the cover page was our D6 serial # D6 9u8211 On the D6 tractor book it has these #'s 4 R 5 R 8 U and 9 U series
  9. D

    D6 9U engine service book and tractor book

    Have a service reference book for the engine and the D6 9u tractor for sale.Price??279 pages on the engine one and 195 pages on the tractor manuel.Dave 320-583-1033
  10. D

    7120 hdry.couple to 1175

    Wondering if I can put a 7120 hydraulic coupler system on a 1175 by taking the case coupler off and using the 7120?Any idea if this will work,like the ease of hooking up the hdryl.fittings to the newer system!Also anyone know if there is an adapter from pipe to case to adapt the different hose...
  11. D

    Case 10 foot Disc - Trying again

    I have a 10 ft. and they are very hard to find parts(bearings and correct spools)for it.have to make them!!Dave A
  12. D

    300 steering gears question

    Replaceing the gear that has 2 points with one that has 3 points.They look the same except for the extra point on the replacement one.Tried to adjust the new one by shimming the gear up some but it did not help much.Dave A
  13. D

    300 steering gears question

    Having trouble getting the worm gear to rightly turn the 3 spot gear mechanism.Are there timming marks that I need to know about and how do you get that worm gear to strike the 3 points?Help needed please and thanks for any help you can offer!!Dave A
  14. D

    590 case backhoe bucket removal problem question??

    Trying to take the bucket off my 590 case backhoe but cant get the main pin out.Will move 1 in back and forth but hits sold metal inside the boom beyond that.Used a hand mall but was wondering if a large mall should be used to drive it out?Need to put a larger digging bucket on!Thankyou for any...
  15. D

    gear oil in a torque transmission question!

    Why does the torque pressure guage get into the red after about a half an hour of pushing and then the torque temp guage starts to heat up?Had the radiator and oil cooling radiator cleaned out inside and out and installed new lines as well with no inmpovement.Dave A
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top