(800) 853-2651
SHOP NOW

Recent content by David Dunaway

Yesterday's Tractor Forums
  1. G

    pillowblock bearing

    What is the best way to remove old bearing from pillowblock? Has some rust.
  2. jon f mn

    Cut some oats yesterday

    Got started cutting oats yesterday, they are really crappy. But I guess that's the way it goes sometimes. Did have some carb issues, but got those figured out and she runs great now. Also worked on the combine some. The lower sieve was busted up badly because the front holder was s...
  3. G

    Telemarketer Using Pay Phone,

    Yep! That was the case a few minutes ago. Must be a smart pay phone. I could lower my interest rate as LOW as 6.9% by just pressing 1 to get it! Guido. <img src="https://www.yesterdaystractors.com/cvphotos/cvphoto9742.jpg">
    • guido
    • Post #1
    • Forum: Tool Talk
  4. A

    John Deere GT225

    I am looking to remove the engine from this John Deere GT225 garden tractor. I will have to remove the belt and the PTO from the crankshaft. I have removed the bolt from bottom but it did not come off. What else could be holding this on??? or what attempt do I use to get the PTO and the...
  5. T

    NAA Cntr housing Hyd

    Well this can't be good. Since there are O-rings to seal, I can only guess the oil in the cracks is residue. Anyone else run into this ? Ran brake clean on it awhile and with air there is still seepage a little. Spose I should take if off, remove the studs, thoroughly clean threads and JB on...
  6. D

    engine cutting out after warm up!!

    Not yet... was debating on whether to do that. After it sits a while it fires right up and will run great for about 5 minutes, then it starts sputtering. I may try that.....
  7. D

    400 Super diesel

    She looks great!!! Reminds of the one we had for many years. Loved that old tractor. Keep me posted on your progress!!
  8. D

    engine cutting out after warm up!!

    I"ve got a little "57 Case Round Nose 300. Been running fine all summer using a 7" finish mower on 3 point hitch, mowing about 5 acres at a time. Recently, after the tractor is warmed up and running fine the engine goes to missing, back firing. Long story short, I"ve replaced the disturber cap...
  9. D

    310 Round Nose PIC

    Ande, Judging from the front axle you have a 300 ultility tractor. You're proably right that it had a loader on it once upon a time by evidence of damage to the front grill. Something abused the heck out of it. Does it have 3pt hitch, lift arms and the like? I have a narrow front, general...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top