Recent content by david from mo

  1. D

    New Holland 451 convert from single guard to doubles?

    doubles work better under most conditions. cost effective ? not sure unless your old ones are worn
  2. D

    Massey 180 multipower input shaft leak

    Local MF dealer now closed used 1/2 drill and hose to turn pto input shaft.That lets you see where your leak is and repair before putting back together.
  3. D

    Pic-4840 John Deere Tractor Sitting For Years By Hiway

    was thinking it was a Buick.It wasn't a old car when it was chained for damages .I though it was removed a few years ago .I will ask the owner's son if is gone or just covered in brush.
  4. D

    Dodge Caravan

    Without checking in going by memory. You can change that fuel pump by jacking up the van .it up its on the side of the tank might need a special tool to remove the ring that holds the fuel pump in but it only pays an hour labor if I remember correctly
  5. D

    A4.318 Perkins water pump

    replace fan blades
  6. D

    Tire pressure for road use

    Back in the tractor cade to Washington times farmers in this area reversed the tires to drive the 1000 miles to Washington DC
  7. D

    165 - Steering valve actuation link adjustment

    My question is . . . to remove the ball joint, do I just rotate the ball joint screw to get it out? Righty tighty/lefty loosey? No its a tapered stud, the slot is nice to retighten. I would adjust steering on tractor. Heat may be your friend. Many times the lock nut will need to be double...
  8. D

    MF9 / MF12

    ry agcopartsbooks.com to check part numbers
  9. D

    What is it?

    My guess early chevy Corvair
  10. D

    92 Plymouth Colt Vista air conditioner

    The engine control module has control of compressor . I would put battery voltage on yellow wire at compressor. If its cools report back.
  11. D

    MF Needle question

    ]do you need rivets? I got pads from agco and had to buy a box of rivets.
  12. D

    S7 200 amp Inverter Welder review $99

    Same welder same $10 coupon. Shipping address was Hola Cindy,1800 Worldwide Blvd, Herbon Ky 41048 . I just checked still in stock still $99 .I have never weld was surprised with help from my nephew I was welding.
  13. D

    S7 200 amp Inverter Welder review $99

    After your review I purchased one .I was very well pleased.
  14. D

    O/T: Suspension bushing, stuck bolt... how to heat?

    I just went down that path on a 07 Dodge Dakota .I removed one by using my ball joint press. The other one not so good, the bushing pressed out of lower control arm! The customer okayed a new lower control arm.

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top