Recent content by davidroller

  1. D

    1962 Farmall 504 Row Crop wiring issue

    It may eventually stop on its own, but I do not let it continue. I have to let clutch out with it in gear and brake on to kill it. Thank you
  2. D

    1962 Farmall 504 Row Crop wiring issue

    I verified the diode is installed in with the correct bias, but are you saying to run this wire to the key switch instead of the battery wire? Sorry, didnt follow you there. As I posted this #1 wire is only connected to the GEN light now, which feeds back to the ignition connection on the...
  3. D

    1962 Farmall 504 Row Crop wiring issue

    I removed all wires from the alternator, started engine, let it warm up, and it still ran on. Going to pull coil wire as suggested by another member next. If that kills the engine, then I am wondering about voltage pass by on switches, starter button, etc. ??? Thank you for your...
  4. D

    1962 Farmall 504 Row Crop wiring issue

    I will try that next. I did disconnect all the wires from the alternator, so only battery power, the engine still ran on. If it dies with coil wire off, and you look at the wiring explanation I posted, what would be you thoughts after that. Could an aftermarket switch or starter button...
  5. D

    1962 Farmall 504 Row Crop wiring issue

    I guess I just meant it runs on, not dieseling. Thank you for the response
  6. D

    1962 Farmall 504 Row Crop wiring issue

    Hello, I just purchased this tractor and I would appreciate any assistance on the 3 issues I have on this tractor. Probably all related. Tractor runs on ( diesels ), when key is turned off. ( PROBLEM # 1 ) * I believe it to be electrical. I have adjusted timing both advanced and...
  7. D

    Implement Identification

    As I look closer, looks like two implements pushed together
  8. D

    Implement Identification

    It appears to have side shift chains and beams, so I would say a cultivator of some kind. These would assist in keeping the shanks in line as the horses moved side to side. Usually controller with foot pedals
  9. D

    Hydraulic cylinder stop

    Hello, I am looking for a few old style hydraulic cylinder stops like in the attached picture. Please left me know if you have any extra you would like to sell. Thank you
  10. D

    Oliver Super 55 oil filter base assembly

    I am looking for an oil filter base assembly for an Oliver Super 55. I would prefer the steel version, but aluminum work possible work also. Thank you Dave
  11. D

    Super M hunting

    Choke helped, so I adjusted idle air screw and issue seemed to clear up. Concern is the idle air screw is all the way in. Thoughts?
  12. D

    Super M hunting

    Hunts, even when not at idle
  13. D

    Super M hunting

    Forgot to check that, will in the morning Thanks
  14. D

    Super M hunting

    <video width=90% src=https://www.yesterdaystractors.com/cvvideos/cvvideo93437.mov controls>http://forums.yesterdaystractors.com/cvvideos/cvvideo93437.mov</video>
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top