(800) 853-2651
SHOP NOW

Recent content by Dayong

Yesterday's Tractor Forums
  1. D

    Engine repair

    Hi, I could use some advise before I make the next move. I made a big mistake when combining with my gleaner F. first day I checked the water and it was good. the second day I didn't check, so I don't when I ran it without water but I did for a while. I managed to drive it back in the barn and...
  2. D

    hay baling rate

    I have a question for you farmers. What is the fair or going rate to bale someone field (I would cut, rake and bale). His field is already been plant before and I would like to know what shares should I get. Thanks in advance for your responses
  3. D

    IH 300u running bad

    the only thing I think I can add that might help is it begins to run bad when warm and under load. running warm and not under a load it just misses occasionally. seen black smoke before redoing the carb. before I rebuilt the carb I had to adjust choke to get it to run a little better. after...
  4. D

    IH 300u running bad

    thanks, I'll give it a try
  5. D

    IH 300u running bad

    no inline filter, I cleaned the screen in the carb, only other thing is the sediment bowl(sp)
  6. D

    IH 300u running bad

    Ok, I'll give that a try, Also, I'll check for a good ground. thanks again
  7. D

    IH 300u running bad

    Need some advice. My IH 300u has been running bad lately when it gets warm. Things I have done to help correct this issue are checked the valves for proper setting, rebuild my carburetor, checked the breaker point for proper clearance. The cylinders are running just above 90psi each. Does anyone...
  8. D

    carburetor

    Does anyone know if the Farmall 300 and the International 300 Utility use or have the same carburetor? Thanks for your info
  9. D

    engine

    I checked the compression on 3 cylinders, the one on the water pump outside was 30psi, the one next to it was 90psi, and the third from water pump was 120psi. even after adding a shot of oil, the psi stayed the same. Am I to assume I need a new head gasket or could the rings be bad. I did run...
  10. D

    engine

    Thanks for all the help. From all your advice that I have gathered, the gas situation is ok, now I will make sure the battery is fully charged and I will buy a compression tester to test the cylinders for compression. I wanted to get it started over a month ago to cycle the new antifreeze I had...
  11. D

    engine

    Hi, I'm not much of a mechanic so I need to ask for some advice. My combine engine (Gleaner F)will not run, its getting spark to the cylinder and after I stop cranking the engine I have gas come out of the carburetor. So is my float stuck and its getting too much gas? and that's the reason why...
  12. D

    Pole Barn Condensation

    This message is a reply to an archived post by UP Oliver on June 30, 2013 at 18:17:00. The original subject was "Pole Barn Condensation". I just came back from my pole barn at 11am. I have a lot of moisture (frost on inside the roof)in my barn and its dripping. I have a ridge vent the eves are...
  13. D

    7000 planter

    thanks for your comments. its listed for 600.00, I thought it would be a good project for me this year
  14. D

    7000 planter

    thanks for your reply, I currently have a IH 400 cyclo which works but its not accurate, I think because of the long seed tube that the seed has to travel is about 5 feet long makes the seed spacing not accurate? I'm looking for a planter that is more accurate.
  15. D

    7000 planter

    yes, I understand it would cost a lot for parts. its listed at 600.00, its worth that for weight and the cylinder. if I bought parts, which looks like the hoppers and a different tongue, how much money would I have into it and what would it be worth? I have'nt seen a 7000 go for anyting less...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top