(800) 853-2651
SHOP NOW

Recent content by dcassill

Yesterday's Tractor Forums
  1. D

    AC WC finale drive

    Had to remove a mounting bracket
  2. D

    AC WC finale drive

    I do have that plug but it is covered up by a casting
  3. D

    AC WC finale drive

    This does not have that plug. Steel final drive not cast
  4. D

    AC WC finale drive

    How do you check and add oil to the final drives
  5. D

    1948 a misses under load on right side

    Ill double check that. It hasn't been painted
  6. D

    1948 a misses under load on right side

    Valves and seats where redone while head was off. Manifold has a crack in the exhaust that has been welded but is in question. Might be my next step
  7. D

    1948 a misses under load on right side

    By the way I forgot to mention it backfires through the intake
  8. D

    1948 a misses under load on right side

    Seems to be getting plenty of fuel. Been through the carb several times now
  9. D

    1948 a misses under load on right side

    Autolight 3116. A fresh set just in case
  10. D

    1948 a misses under load on right side

    Doesn't seem to matter. Tuned to wear it runs best it still misses. Maybe 2 turns
  11. D

    1948 a misses under load on right side

    Light load like taking off in high gear. No water in fuel
  12. D

    1948 a misses under load on right side

    Distibutor ignition, changed plugs, coil, points, condenser, wires, cap and rotor, swapped carbs, checked valve lash, seems to have good compression. I cannot get this figured out. Any help would be appreciated. Btw I got this tractor in boxes and this is how it ran when assembled. New...
  13. D

    Net wrap

    What is a good inexpensive entry level net wrap bailer to purchase. Looking to upgrade my operation.
  14. D

    66 ford 4000 power steering issue (3 cylinder)

    well the power steering works but needs some fine tuning. now my problem is my pump is leaking into the crankcase. can these be resealed or do i need to find a pump?
  15. D

    66 ford 4000 power steering issue (3 cylinder)

    ill look into that when i get it home...how about the ball cup on the cylinder side? if that hangs up some will that cause this issue? my thinking it would work one way not the other
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top