Recent content by Dee L.

  1. D

    IH 364 diesel British

    Thank you Jim I will check those out.
  2. D

    IH 364 diesel British

    Thanks Used Red MN, I think the pressure is about 800lbs. in the power steering system. But good to know more about where else this type of washer/seal could be used.
  3. D

    IH 364 diesel British

    Thanks Mark!
  4. D

    IH 364 diesel British

    I'm working on my IH 364 that was made in England. It's been tough finding the right parts since it's both old and foreign-made. Right now I'm looking for washers for the adapters (banjo fittings) that connect the hose to the powering steering cylinder. We tried copper washers but it's still...
  5. D

    IH 364 Diesel British :: Fuel Sediment Bowl

    Thanks wore out. This part number turns out to be the wrong size. my bowl is 2.5", that one is 2". it's an older assembly, and looks the same as the one in the manual but i guess it must have been replaced at some point. the guys at Townline Case IH in NH have been helpful but it's a bit of...
  6. D

    IH 364 Diesel British :: Fuel Sediment Bowl

    Hi good morning, This tractor has a sediment bowl assembly with 2.5" OD on the glass bowl; this gasket is proving hard to find. I will likely replace the whole assembly, but just curious if anyone has leads on finding a gasket of this size? thanks! -DL
  7. D

    International B275 Glow Plug Resistors Element.

    I have a 364. we had replaced the plugs but not the wiring. been using ether, works OK if we get it right. a couple questions: Can I replace the nichrome with heavy wire? A friend of a friend recommended 10 gauge but if it has resistor wire on it then i would want to replace with the same...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top