Recent content by Deere Driver

  1. D

    Engine Block Heater Malfunction on JD 3020D

    This is a small cannister unit that is outside the block. It is a John Deere unit and was installed in 2013. I will check further on tomorrow. Thanks to everyone for your comments/suggestions.
  2. D

    Engine Block Heater Malfunction on JD 3020D

    This is a small cannister type of heater that is in the middle of a water line to the block.
  3. D

    Engine Block Heater Malfunction on JD 3020D

    I plugged my Block Heater in this afternoon on my JD 3020D. Seemed like it took longer than normal to start heating. I worked on something else for a while and came back to the tractor, expecting the water hose and heater to be hot. They were cold, which suggests to me that heater has quit...
  4. D

    John Deere 3020 Diesel Temperature Gauge

    Thanks for your advice. I probably need to run this by my mechanic. I believe I can install the new gauge, but it that's not the problem, better get some help. Thanks again for your thoughts.
  5. D

    John Deere 3020 Diesel Temperature Gauge

    It had been a couple of months since I ran my 3020D. When I started yesterday, the temperature gauge never started working, even after running the tractor about 20 minutes and driving it a short distance. My guess is the temperature gauge is shot. How difficult is it to install a new one?
  6. D

    John Deere 570 Manure Spreader

    What are the pros and cons when considering the purchase of a good used John Deere 570 Manure Spreader? Was this a well designed model when new?
  7. D

    No Power to Rear Auxiliary Electrical Plug

    Thanks for all your help. Tractor was converted to 12 volt about 6 months ago. Plug was hot before that. Probably lost the connection when that process was done.
  8. D

    No Power to Rear Auxiliary Electrical Plug

    The 2-prong auxiliary electrical plug on the rear of my 1964 3020 Diesel is dead. Is there a short-cut way to trace the wiring to find why there is no power getting to this plug? This tractor has been converted to 12-volt with an alternator.
  9. D

    Changing Bulb on Oil Pressure Indicator Light on Older 3020

    Thanks for all of your suggestions. Sounds like I need to look at the back side of the dash. Should be able to loosen lens bracket from the bottom.
  10. D

    Changing Bulb on Oil Pressure Indicator Light on Older 3020

    I need to replace the bulb on the oil pressure indicator light on my 3020. I can see that the lens is designed on top of a round metal tube with a horizontal slot in the bottom of the tube. It appears to me that the way to remove the lens (to make the bulb accessible) is to push down on the...
  11. D

    Lights Do Not Work Properly on 3020D

    Thanks for all of your replies. I would guess I didn't hook up all of the wires correctly when replacing the starter, but with all of your ideas, I should be able to figure out my problem.
  12. D

    Lights Do Not Work Properly on 3020D

    When turning light switch on my older 3020D, only the dim headlights work...on all parts of the switch. Dual headlights do not come on. Rear light does not come on and amber fender flasher (added for safety) does not work. I just replaced the starter (24 Volt System), but I wouldn't think...
  13. D

    JD 7000 model 100 monitor

    Tell me about the monitor you need to sell. 4 row, 6 row, 8 row? What type planter was it used on? Do you know if it works?
  14. D

    JD 80 unit planters

    They have the same plateless planting process as the 1240 plateless planter. This is the early version of what is now called Deere's finger pick-up system. Most were sold with runner openers. The finger pick-up systems on all planters require maintenance and sometimes need fingers, springs...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top