(800) 853-2651
SHOP NOW

Recent content by Deere Oliver Farm

Yesterday's Tractor Forums
  1. D

    How to start an International 8-16 tractor

    thats when you call your neighbor to crank it...lol
  2. D

    How to start an International 8-16 tractor

    thank you. thats the kiss method...keep it simple student! Ill check it later. Very cold here in upstate NY today
  3. D

    How to start an International 8-16 tractor

    Bob, thank you for that. I see you are in NY also. I'm in Cooperstown, Otsego County. Perhaps the main reason, above all else, I needed advice, was because of the advance/retard position lever behind the steering wheel. I was hoping could address this. Now you mentioned about pulling the lever...
  4. D

    How to start an International 8-16 tractor

    Yes, mine is a 1920 and came from the Gary Sutherby sale conducted by Aumann Auction 2 weeks ag. Today I purged the tank and lines. The gas in it was not old. But the fuel lines were. Cleaned all the spark plug gaps, and wire contacts. I checked and there is a nice blue spark. Now for the 2...
  5. D

    Case 400 orchard tractor

    Gobble gobble! If you can send me pics that would be a start to see if they may work?? Thanks
  6. D

    Case 400 orchard tractor

    I have a Case 400 orchard tractor. It was restored years ago and still looks really nice. However, it is missing the side shields. I may be able to recreate them from pictures and have a good sheet metal person make them. I just figured they would be tough to find otherwise. Any advice? I live...
  7. D

    Removing rear wheel Hart Parr 18-36

    I'm going to remove the rear steel wheel from my Hart Parr 18-36. I took the hub cap off and there are 2 bolts under it. In addition, I see there are also 4 large nuts that appear to obviously hold the wheel on. Can I only remove those 4 nuts to remove the wheel or do I have to do something with...
  8. D
    Expired

    Wanted Wanted

    I need a usable 11.2 X 34 inch tire for my John Deere 40 that is a working tractor at my farm. I want someone who lives here in NY or someone who will be attending our state Pageant of Steam show in August. Just not practical if you live a distance away for just a tire. Thank you...
  9. D
    Expired

    Wanted Wanted: Gray tractor manual

    If anyone has an owners manual for a Gray Drum Drive tractor please let me know. [email protected]
  10. D

    Hart Parr 19-36 hard to put in gear

    I got it outside and now I could see better that the throw out bearing was dry. I put grease into those 2 zerks, along with a little grease on that shaft and now she engages and disengages just fine. Thanks!
  11. D

    Hart Parr 19-36 hard to put in gear

    Well rrlund, you were on the right track. When I got it outside into brighter light, I see the throwout bearing was dry looking, along with some surface rust on the shaft that the bearing travels on. I cleaned it up, put grease into the bearing zerks, and problem solved. Thanks!
  12. D

    Hart Parr 19-36 hard to put in gear

    Thanks for your reply Scootergmc. When I finally pulled it out of the barn into bright sunlight yesterday I noticed the throwout bearing had 2 grease zerks. They were bone dry when I pumped grease in. I worked the clutch back and forth. Gave it a whirl and problem solved. It runs great, but a...
  13. D

    Hart Parr 19-36 hard to put in gear

    I just purchased a Hart Parr 18-36. Did some carb work and got it running nicely. But it grinds when I try to put it in any gear, even if I idle low. Keep in mind the clutch appears to engage and disengage when I pull the clutch lever or push it forward. Any suggestions?
  14. D

    Timing a Cub with dial indicater

    I'm helping a friend time his Farmall Cub correctly. I always used a dial indicater to find exact TDC. Should the Cub spark exactly at top dead center? Or should the spark occur a little before? How many degrees before? Last tractor I did was an Allis B and I set it to spark at about 3 degrees...
  15. D

    JD 40 rear fluid

    I use my JD 40 with a 5 foot brush hog to do pasture. Lately I've noticed a puddle of oil under the rear of the tractor. It is slowly leaking from the unit under the seat somewhere. When I went to brush hog yesterday, the PTO did not want to turn. Also, what type of fluid goes into the filler...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top