(800) 853-2651
SHOP NOW

Recent content by deerlyparted

Yesterday's Tractor Forums
  1. D

    JD GM leaking oil into right cylinder

    Started G yesterday and it was only firing on the left cylinder. It had minimal exhaust coming out the petcock on the right cylinder upon startup with petcock open. I removed the valve cover assuming I had a stuck valve. All is well with valve train. Got a bore scope camera to investigate...
  2. D

    Hands on fire (OT)

    Happened to wife several years ago. Think we finally used milk to soak hands in. I know it is only thing that works when you eat something spicy hot.
  3. D

    Kubota B2150 3 Point lift surges

    Any ideas as to why my 3 point hitch surges or hunts for its correct position when it has any load at all on the hitch? Something with control rod or maybe something broken in valve feeding the hydraulics for the hitch? Anyone have repair instructions from service manual? . It is the manual...
  4. D

    silverado severe shifting

    I had same problem on my 2000 GMC 2500 with 4L80E transmission. Had to go thru a certain shift pattern to act up but would then kick hard between shifts. I messed with replacing the shift solenoids to no avail. Finally switched out torque converter for <$200 bucks and wow, problem fixed...
  5. D

    row crop 4320 dies when idling

    Recently my 4320 row crop diesel has been suddenly dying after idling for a few minutes. It will then not re-start for 20-30 minutes. After sitting for that long it will re-start and run just fine. It's like the fuel gets shut off. Each time it has died is during idling. Any ideas on what my...
  6. D

    6432 Sunflower soil finisher

    Any sources other than the dealer network for parts? I called dealer for s tine shanks and blades for the chopper reel on my finishing tool and about fell over when they quoted 110 and 30 for these. I tried Shoup, Sloanex, Tractorpartsasap and another but no one can get these parts. Any other...
  7. D

    CMC Grain Bins?

    Has anyone had any grain bins built lately? I'm pricing a couple 36' diameter 6 ring storage bins(20,000 bu.). Has anyone had really good or really bad experiences with any of the manufacturers? Who's good and who's bad and what to look out for. What has everyone done for foundations on...
  8. D

    OT. Chevy Captiva

    Looking at a 2103 Chevy Captiva (small SUV) with 50000 miles. Does anyone have any experience with these? Good or bad? We have a 2006 Pontiac Torrent and are looking to upgrade a few years.
  9. D

    HEL coming out of pasture to be Row Cropped

    20 acres. I farm a few hundred aside from full time work. I have all equipment needed. Plan to keep it in row crops.
  10. D

    HEL coming out of pasture to be Row Cropped

    Got a new piece of land in the works. It's been in grass/clover hay for past 6-8 years. I need to mow it off as it didn't get cut for hay a second time this year. What's the best plan of attack to get it ready for spring crop planting? Getting soil samples pulled now. May spray it this fall...
  11. D

    Vacaction Spot on Gulf, Destin or Gulf Shores

    OT. Anyone had any good experiences along the gulf coast in recent years? We're looking for a place to visit in possibly Destin area or Gulf Shores. Anyone got any hot spots that wont break the bank down that way? Never been to the area but want to try it. Thanks.
  12. D

    1790 JD Planter calibration and closing wheels

    I have a vacuum metered 16/32 planter with ESET. I was wondering how often you calibrate the row units? Also, have any of you switched from the solid rubber closing wheels to one of the steel or poly tined wheel to break up the covering soil better than the rubber wheels? Some test plots I...
  13. D

    Jamaican Lotto Scam

    well said.
  14. D

    Jamaican Lotto Scam

    Heard about this on a website I stumbled across. What a scam. Anyone know anyone duped by this scam? Sounds terrible. Lots of people have been wiped out of their lifelong savings in a few months.
  15. D

    Unverferth 9200 and 9250 grain carts

    Anyone had any good or bad experience with Unverferth 9200 or 9250 carts? I'm looking at buying one and have found a couple. They look like nicely made rugged carts. Any good or bad news on them out there in YT Land? Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top