(800) 853-2651
SHOP NOW

Recent content by Dennis Zembower

Yesterday's Tractor Forums
  1. D

    Case 300 or 310 Anyone know anything about these tractors?

    Photo missing from first post.-DZ
  2. D

    Case 300 or 310 Anyone know anything about these tractors?

    Here is my 310 wheeled utility with round nose. The tin and grill are removed for restoration. Anyone having a hood and doors for this beast please let me know. DZ
  3. D

    Why I became a Case Collector

    Nick Have you ever had issues with the dual range popping out of gear. Mine does in spite of replacing the detent spring and new woodruff key on shifter arm. The forks and spacer ring show some wear (see photo) but cannot believe that is the problem?- DZ in NC
  4. D

    Any Other Dual Range 310's out there?

    Stephen-Finally took the starter back to my service guy and he replaced the solenoid,no charge! Now it cranks every time. Replaced plugs, coil (12volt for 6 volt and removed the resistor). Runs the best ever. Now am finding an fixing oil leaks. The pan gasket seems to be leaking and I will have...
  5. D

    carb air intake on 310/320 - picture

    Joe-Found the problem. If you swap the 2&3 plug wires not only will it not run well it won't run at all!! Dumb mistake on my part. Runs like a top now. Thanks for all your help.-DZ
  6. D

    carb air intake on 310/320 - picture

    Joe-Thanks very much for your reply. I since had my starter guy replace the solenoid and it turns over now fairly reliably. However the fuel system is very "touchy" now after rebuilding the Zenith carb and throttle linkage, which seems bass ackwards. When you push the hand throttle towards the...
  7. D

    carb air intake on 310/320 - picture

    This message is a reply to an archived post by Michael Donegan on September 30, 2011 at 17:13:05. The original subject was "carb air intake on 310320 picture". Joe(Wa)- You mount the solenoid on a steel bracket near the fuel tank. Can you share why you place it there and how the wiring harness...
  8. D

    Case '56 310 Backhoe Stalls

    Recently rebuilt the Zenith series 61 carb, new 12 V coil, and thoroughly cleaned and lubed the throttle linkage. Now the beast starts and idles but stalls under load even when warmed up. Fuel drips out of the intake when she is not running. What is going wrong here? Dennis in NC. :roll:
  9. D

    310 PIC,bought it tonight

    Adirondack- How did you make the side panels, they look great!-North Carolina Case Guy
  10. D

    case 310B brakes

    Hey Joe- I have posted several inquiries but have not received any responses. What am I doing worng?-Dennis Z
  11. D

    310 Utility Dash Throttle-VTA 655

    This message is a reply to an archived post by Joe Wa on February 27, 2011 at 21:58:13. The original subject was "Re: 310 Utility Dash Throttle". Joe-What function does the part number VTA 655 perform. It looks like a diaphragm of some sort?-DZ
  12. D

    Any Other Dual Range 310's out there?

    Stephen - The problem turned out to be the battery connection to the solenoid and the solenoid not grounded to the starter properly. I cleaned all fittings and wire brushed the starter carcass where the solenoid resides and the starter attaches to the tractor body. Had to double nut the battery...
  13. D

    Any Other Dual Range 310's out there?

    Stephen Good advice, I will get all the grounding points back to metal and see if this corrects the problem. Will let you know how it works. Thanks for the insight.DZ
  14. D

    Any Other Dual Range 310's out there?

    Stephen-Thanks for the reply. The solenoid only "clicks". The starter is newly rebuilt and seems strong when it is engaged. Would you recommend attaching the Battery Ground cable directly to the solenoid ground strap connection? Currently it is attached at the starter motor top mounting bolt.I...
  15. D

    Any Other Dual Range 310's out there?

    I have a 310 wheeled utility tractor with dual range that I am restoring. Currently having trouble getting it started, even with new harness, battery and starter/solenoid? It is a 6 to 12 conversion that ran fine for a week now won't start.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top