Recent content by DevonFarmer

  1. D

    JD 2355 front hub/planitary seal

    I have a john Deere 2355 mfwd that has a bad seal on the front hub where the front axel drive shaft goes into the planetary for the front wheel. Got the seal on order from JD, but I was just looking for any advice or info anyone has on what to check for wear on any other parts once I have it...
  2. D

    Kuhn GMD500 manual

    Forgot to put in my email, [email protected]
  3. D

    Kuhn GMD500 manual

    Does anyone have a pdf of the operators manual or service manual for the Kuhn GMD 500? I picked up a 2011 model mower, but it didn't come with manuals and I want to make sure everything is serviced and gone over correctly before using it this summer... Thanks for the help!
  4. D

    JD 2355 4wd solenoid has no power

    Dug into the dash more, found the fuse block located just bellow the tachometer, pulled out the circuit board the holds the fueses. The fuse hadn't blown, but a section of the actual circuit bord melted/burned..... Little creative soldering, and the tractor is back up and working! Thanks...
  5. D

    JD 2355 4wd solenoid has no power

    Thanks, metered out with no current and a jumper wire from battery will engage solenoid to shut off the 4wd. So I am guess that leaves either a fuse or the circuit board.... The only two fuses I could see where located at the top of the dash, and they checked out fine, are there more fuses else...
  6. D

    JD 2355 4wd solenoid has no power

    Thanks, metered out with no current and a jumper wire from battery will engage solenoid to shut off the 4wd. So I am guess that leaves either a fuse or the circuit board.... The only two fuses I could see where located at the top of the dash, and they checked out fine, are there more fuses else...
  7. D

    JD 2355 4wd solenoid has no power

    Had the four wheel drive solenoid power wire end up grounding out while feeding the cattle today. The result was the the gage cluster lighting up the Battery indicator light and the four wheel drive indicator light going out. Now I have repaired the grounded out wire, but the problem is that...
  8. D

    3020 load shaft seals

    Used the Boling Machine seals for several years with great success!
  9. D

    John Deere 3020 Motor swap

    Tim, Thanks for the advice, I will make sure the linkage is worked out before the motor is put back in! If you have any more suggestions, I would sure would appreciate it!
  10. D

    John Deere 3020 Motor swap

    Thanks Jim, thats All I needed to know! Should be a fun project!
  11. D

    John Deere 3020 Motor swap

    I have been running a diesel John Deere 3020 for several years, in which the motor had in frame rebuild with less then a 1,000 hrs. The tractor has some other mechanical issues that make not field ready for this year. I have the opportunity to pick up another 3020 gas job with 1,000...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top