Recent content by Dick B

  1. D

    Please help wil John Deere A

    Thanks, Checked that this morning ,, tight on shaft,, T.Y.
  2. D

    Please help wil John Deere A

    runs up to 1500 rpm at flywheel. I think we need to look inside again. Thanks
  3. D

    Please help wil John Deere A

    the governor housing where the brg fits on the Dist side was worn out. Wwe had to reem and put a sleeve in it. Will take it out again and check weights. looked kinda chewed on
  4. D

    Please help wil John Deere A

    Thanks will try that 1 rst
  5. D

    Please help wil John Deere A

    Older hand start A Starts good, Runs very good at idle and high speed The problem is no mid range,..... Move the throttle just a hair and it goes from idle to full speed. Had to dealer who is an expert at 60's and 70's tractors but not very well versed in 2 cyl. He removed and went over...
  6. D

    Please Help With John Deere A

    I have a old hand start A that starts and runs very well. Problem is , it idles great it runs well at high speeds but there is no mid range. move the throttle just a hair and goes from idle to full speed. Had to a dealer who took apart the governor, installed the 4 new brgs. and checked...
  7. D

    Kubota G2460 Lawn Tractor

    Hey, I just bought a Kubota G2460 Tractor with a 60" Deck and a snow blower. Thye tractor has 95 hours on it, the blower is new. It is 05 or 06. Can anyone tell me if these are good? P.O.S.? or much about them. I bought it to re-sell ( isnt green & yellow ). Is $6100 a fair price...
  8. D

    4020 hydraulics

    If you have splitting stands or some safe way to support the weight of the front end , remove front axle is easy. If you do not have the heavy tools , support the oil pan with a 4 x 4 and bottle jack and remove side frame rail. Our mechanics usualy remove frame rail because it is faster and...
  9. D

    Frontier wheel rake

    I thought most all finger wheel rakes were Italian. Sitrex or Tinnuti ( sp ) sometimes you can get a rake like Kelderman Mfg who buys the rake wheels, arms etc. and installs them on there USA made cart. Now maybe a frontier is US made I am not sure. But I do know if you are worried about...
  10. D

    John Deere Patio tractor

    I have a JD patio tractor ( red and white ) I would like a ballpark idea on value I have mowed with it for years now it has been in storage for 15 + years. The seat has been stolen, The front of the red hood is cracked. Other than that it ran good before we put it in inside storage. Thanks...
  11. D

    OT/loosing my mind part MMCMLXVIII

    HMMM, I was going to write something smart but forgot what it was @ 49 years young
  12. D

    4430 tractor

    It would look cool if it had a set of front fenders on it
  13. D

    $60K John Deere G

    Have you ever sold anything and later thought,,, gee I should have asked more money for that! That guy is not going to let that happen.
  14. D

    cracked cast rear wheel

    We have found that if you sleeves are worn out it will crack the replacement wheel too !
  15. D

    4320 question and 4430

    what we have found dealing with tractors for the past 20 years is, Dont always believe the hour meter unless you know the person who has had it for the past 25 years. It may have been installed at the last overhaul. Check the wear on the 3 point , clutch and brake pedals etc. As far as the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top