-
D
max bore in a wc block
I leave at least 1 1/2" of room for water, and bore top of block larger (under block top surface)so water can get around.- diesel puller
- Post #1
- Forum: Allis-Chalmers
-
D
max bore in a wc block
4 5/8 goes in, 4 3/4 works but are hard to hold- diesel puller
- Post #1
- Forum: Allis-Chalmers
-
D
John Deere A pistons
The cylinder should finish at 5.625, what they bore to is up to them. Should bore less to leave for honing.- diesel puller
- Post #1
- Forum: Tractor Pulling
-
D
class project
Nice job. now figure how to get air in and out with a dam in front of vavles. The plugs were machine alot different than what you made.- diesel puller
- Post #1
- Forum: Tractor Pulling
-
D
A little trivia.
Need more info. how wide, what diameter, what hub size,recess one side or two and what grade of stone?- diesel puller
- Post #1
- Forum: Tractor Pulling
-
D
need help ..with SLEAVES ?..
no will cut thru oring grooves- diesel puller
- Post #1
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy