-
Difference between tsx 593 and tsx 765 carb. Help!
Dean Diggerdon Here. I have an 860 and need to to prove mine is bad. I did not see how old this post is. Maybe you can help me find TSX593 or equivalent. '' -
LX178, 188, 279 JOHN DEERE PLUGS
I have a lx279 and I just replaced the plugs. BPR2ES, they look long. Does anyone know what the correct NGK ? I am trying to stop the engine from loping at low speeds. Fast speeds are fine. Need help- Diggerdon
- Post #8
- Forum: Garden Tractors
-
1959 ford powermaster 801 or 861
Little late with my reply. That hole your looking at is to see the timing marks. This is to set the timing and should be dry, or semi dry. By pulling off the square bottom plate you should be able to see how much oil is leaking and get an idea where from. -
Ford Backhoe 713
I have a ford backhoe 713 series 19-153 on an 821. I have the service and parts manual. Is there a " operating and assembly " manual, like I have for my loader (19-97)? [/img:0d4dc7b0a0] -
821 Power Steering Cylinder
Cut open cylinder, removed rod. What parts do I replace on the rod? Inner cylinder and cast-iron cup with ring, look awfully pitted. Going to try brake cylinder hone to take out some of the pits. -
821 Power Steering Cylinder
Thanks for the info. On a budget, I will give it a try and see what happens. -
821 Power Steering Cylinder
If it is leaking inside can the cast iron seals be replaced? When you cut the end, do you only cut the outer tube or cut the end clear off? -
821 Power Steering Cylinder
Have an 821 and I need to rebuild the power steering cylinders. Both are leaking inside cylinder. I ordered seals needed for the end of the cylinder. Can anyone tell me which end of the cylinder I cut off, to remove and replace the rod inner cups? I will braze back on after replacing the inner... -
-
-
-
713 backhoe
I have the parts & service manuals for the 713. What manual are you using to get the procedure? I need to buy that one. Thanks for the help. -
713 backhoe
I have a ford 821 with a 713 backhoe mounted on it. Does anyone have a procedure for removing it from the tractor? It looks like a factory mount. -
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy