(800) 853-2651
SHOP NOW

Recent content by DKase

Yesterday's Tractor Forums
  1. D

    Flywheel question for CC/DC

    To add a starter to a 1934 CC you will need a DC engine with a DC flywheel, and you will have to cut part of the DC bell housing out and weld it into the CC bell housing so there is a place to install the starter into.
  2. D

    Case 930 Hydraulic Valve Relief

    We pushed the pressure to 2000 to lift a very heavy ridge till cultivator on the 3 point. At that pressure it is possible to crack the front side of the remote valve. We did it twice over the years.
  3. D

    Case SC Oil Bath Air Cleaner Reservoir Repair

    I have brazed many with very good results.
  4. D

    1938 C Case Top Radiator Tank

    Contact Vaughn Powell in Riley KS. 785-410-3720
  5. D

    New to me 1956 case 311 questions

    Most engine parts are available. Std Mains were not available 1 year ago.
  6. D

    Got another calendar

    Did you catch him in time to save his ears?
  7. D

    1942 Case DI Pressure Plate Help!

    Yes, took several hours.
  8. D

    1942 Case DI Pressure Plate Help!

    The foot clutch pressure plate in my 1954 DC was completely broken in half when I got it. That was 40 years ago and there were no parts available anywhere. I took it apart, ground out the crack, clamped it to a 1" plate the same size, set it in a gas grill with the burner rusted out so it burned...
  9. D

    Case 1175 Engine Temperature Gauge Isn't Working

    There was a SN break on the 70 series, before and after were different senders and they do not interchange.
  10. D

    Case CC Wheel Spacers

    I have one set on an early CC with cultivator, and several sets laying around. No pictures handy now.
  11. D

    Case 1030 Hydraulic Pressure-Question for John Saeli or others

    1030 has a dry clutch so there is no way that stuff from the clutch could effect the hydraulic system. If you leave the hyd. pressure at 2400 PSI and run it to relief pressure you will eventually crack the front side of the remote valve. Did it on our 930 when we pushed the pressure up to lift a...
  12. D

    oil pressure relief valve

    Take a pressure reading at the block oil gallery as others have advised. My guess is you are OK. I installed a 930 oil pump on an 830 when the balancer broke off. Pressure relief was stuck on the 930 pump. When I started it the cannister oil filter blew off and flew about 50 feet. Stripped the...
  13. D

    Case magnetos

    My magneto guy told me he can install a Fairbanks coil in a Case mag for $50. Lynn Borgers Howard SD.
  14. D

    1950 case DC double hydraulic pump. HELP

    Is it only the 3 pt, or any remote cyl? If both you have check valve problems in the head of the control valve, If 3 pt only you have seals out of 3 pt cyl.
  15. D

    1950 case DC double hydraulic pump. HELP

    I have installed a 930 pump/valve on a DC, but I had to build my own drive coupler that is much thicker because the housing is deeper for the PTO clutch with more plates. Chain drive tractor Hydraulic pumps turn backwards to gear drive tractors.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top