(800) 853-2651
SHOP NOW

Recent content by dlauer

Yesterday's Tractor Forums
  1. D

    O/T Ford 6.7 problems.

    can happen on 6.4 if not deleated but not on 6.7.It has the DEF unlike the 6.0 and 6.4
  2. D

    Re: 129 Haybine pics

    mine has one so i assume they did
  3. D

    2000 f250. what are your thoughts...

    check battery voltage first.
  4. D

    Bobcat T650 vs Case TR320

    I have a case TR270 and love it.Hardly use my old bobcat anymore.It will lift 2700 lbs. Are you sure you need one as big as you are looking at?It would be a beast but it is pretty long.
  5. D

    Million Dollar Rebuild Question

    you might check to see if Dorman repair kit #42025 (advanced autoparts) or ebay will fit.Works on 5.4 motor and at about $50 its simple
  6. D

    Brake problems

    Correct for pistons not getting neverseize.I placed neverseize on slider pins(dual piston calipers).IMHO the super duty design is not very good on brakes.Easy to work on but still not happy with them.
  7. D

    Brake problems

    Im guessing lack of lubrication(dry).If rubber gets bad dirt and grime enter but only causes random dragging.Again just a hunch.could probably clean them up and put neverseize on rod if it hasnt gotten too hot
  8. D

    Brake problems

    one was sticking and the other was free
  9. D

    Brake problems

    common problem on fords especially if they sit around too much.My 2008 did the same thing,first the driverside front then the passengers side shortly after.Replaced both caliper assemblies and fixed.
  10. D

    1955 oliver water in oil

    thanks for the advice
  11. D

    1955 oliver water in oil

    My 1955 oliver got hot when the water pump went out and ruined the radiator.I only ran it a couple minutes but it pegged the gauge quick.After fixing the problem i noticed water in the oil.Drained oil and added water but it still leaks.I assume the head gasket or most likely the o-rings on the...
  12. D

    Gehl 1470 Baler linear actuator

    the 11 " actuator from northern tools will fit but u would have to use manual tie mode and it is much slower than factory one.I ended up paying about $700 for the new assembly on a 1470
  13. D

    oliver 129 haybine

    I have a 129 and can measure if you would like.It is wider than a nh 489.U would have to put sideways on trailer and take tounge and pto off.The guards are the same as a gehl as agco wants way too much money for them.
  14. D

    How can I re groove my forklift tires

    find someone who races and borrrow their electric tire groover.You can buy diffrent size blades.Worked well on my skidsteer.
  15. D

    1800 oliver

    thanks, ([email protected])So i just plumb up a single acting valve?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top