-
Ddnd reacted to Jim.ME's post in the thread 190 Allis key switch location of proper color on it with
Like.
He posted a picture of the wiring diagram he has in post 3. -
Ddnd replied to the thread 4x6 gator getting air out.Worked great, thank you again for the information
-
Ddnd replied to the thread 4x6 gator getting air out.Thank you, I’ll try that later this week when I get back to farm..much appreciated. Dan
-
Ddnd replied to the thread 4x6 gator getting air out.I was thinking that I had air buddies in system that were preventing flow. So did an AI search, where one of the suggestoIns was to park...
-
DHi, I have a late 90’s 4x6 gator. Earlier this summer it was geeting hot and anti freeze wasn’t flowing. I removed the water pump and...
-
DHappy last Sunday in August. Thinking about Christmas presents for some family members and wondering if there is someone in the MM...
-
Ddnd replied to the thread ZTU Seat bract reinstall trick.Quick update, I spoke with Ill John and we discussed my options, so to keep my project moving I used plastic zip ties and compressed the...
-
DOk this is a bit new challenge, I removed the seat flat iron on ZTU, a few minutes ago I was trying to put back on tractor but having a...
-
Ddnd replied to the thread Radiator Cap for 1948 ZAU.Any way you can send a picture of what you’re looking for. I might be able to check with my MM friends
-
Ddnd replied to the thread ZTU magneto.Good to know, it seems to start ok and runs decent, I have the radiator off right now to have fixed as weeping a bit on bottom. Can...
-
Ddnd replied to the thread oliver 70 engine.Good morning, I’ve attached two pictures for your enjoyment. I do have a third tractor but didn’t have a picture of it. The Hart Parr 70...
-
-
Ddnd replied to the thread ZTU magneto.Thanks for the leads on what type of magneto might work. We had our show the first week in August and one of our club officers (surprise...
-
Ddnd replied to the thread Partial Preview Eastern Hart-Parr to White Show.Here’s one I had a few years ago, needed lots of weights to hold the front of the 1855 down when out of the ground. I did plow with it...
-
-
DGreat picture and super nice line up. I think i would switch the two tractors on the swather and baler, i baled with a cabless tractor...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy