-
DDoc 2 replied to the thread Computer question.I agree with Apache Open Office. It's free and works well with Microsoft Office documents. Brian
-
DDoc 2 replied to the thread M needle and seat.On the 400 it is a little all the time gas is on at the sediment bowl. On my M it is okay before starting, runs a little rough as if...
-
DDoc 2 replied to the thread M needle and seat.The pin is not cocked and all is free. I will have to look at everything in there. On the 400 there is a slight drip out the weep hole...
-
DDoc 2 replied to the thread M needle and seat.I'll dig into it tomorrow. I did set the float per the directions in the kit. It is a new float, but I will pay more attention to the...
-
DDoc 2 replied to the thread M needle and seat.I'll have to try that. Thanks
-
DIs there a source for a brass needle for the carb? I have tried the viton tip from several different brand kits and none of them hold. I...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy