(800) 853-2651
SHOP NOW

Recent content by Douger55

Yesterday's Tractor Forums
  1. D

    Brought the H home

    Good thought, but you forgot to mention to look for knots in the 2 x. Had a good 2x8 in the truck in carry to level the camper, didn"t notice a bog knott about half way up, thats as far as I got before it broke, the 2x not the bead..LOL Live and learn.
  2. D

    Rear wheel clamps

    Well after much of a struggle finally got the first wheel and tire off. Wire brush, couple more shots of Gibbs, BIGGER cheater, and a little cussing. Will for sure be putting them back on the other way around. Now on to see if I can get the bead broke on the tire.
  3. D

    Rear wheel clamps

    So by "No" i guess tomorrow i get the big tools out and try to get the jam nuts off. Thanks for the reply.
  4. D

    Rear wheel clamps

    On my H, the wheel clamps are to me backwards. I remove the nut from the inside. The jam nut won"t budge, therefore making it very hard to take the wheel and tire off. Is there a right or wrong way for these clamps?
  5. D

    Brought the H home

    Rear Wheel clamps. Is there a right or wrong way on these? Mine have one clamp inside that comes off, but then you have to fight to get the wheel & tire off. When I first purchased this tractor I had to fight to get the wheels off to paint them then fight them back on. Can they be reversed...
  6. D

    Brought the H home

    That"s why I"m hoping I can get them off here in the garage. Then clean up the rims and paint them before putting the tires on. I"m sure the local guy would remove and let me clean and paint then have him instal if needed. Where in Central Il are you? I"m about 20 miles s of Kankakee,
  7. D

    Brought the H home

    Thought I would go and get the H out of storage and home so I can get two new to me rear tires on. Not too cold, around 50 with sun shine. Nice 12 mile ride. Now to see if I get lucky and get the bead broke, might have to make a visit to my local tire shop for some help on this one, but I'll...
  8. D

    what implements can a high crop pull ?

    I will disagree about plowing. I have a 140 Hi Clear and pulled a 2-14 plow this fall. I hadn't pulled anything except a barge wagon before. Yes, I had it as far right as I could, but was really surprised that it did so well. Kinda tough, only run in 1st gear, but grandson had a ball.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top