(800) 853-2651
SHOP NOW

Recent content by Down under farmer

Yesterday's Tractor Forums
  1. D

    Haybine crimping rolls

    Get some angle iron heat bend weld repeat and repeat and repeat.... will never wear it out. We did it to a new holland years ago. Outlasted the machine now we run a Vermeer and it's factory twin steel rolls.
  2. D

    Deutz 4006 Hydraulic System

    Not sure on 4006 but on 7206 8206 the hydraulic fill point is just behind the seat some you need to slide the seat forward a bit to get the oil in. Transmission fill point is usually on right hand side half way along the transmission housing. Both are separate units take different oils
  3. D

    2023.07.13 "Extra" Pic

    What old is new again... even comes with gps and no fear of the satellites dropping out
  4. D

    IH mud flaps.

    Bit of rubber. Masking tape. Tracing paper. Sharp knife. Paint and little time you can make what ever sort you wont. Made many different sorts over the years. Multi coloured no worries cut out one colour paint it when dry retape cut and retrace cut out next lot and paint. Most I have done is...
  5. D

    Re: deutz dx130 slipping

    Did you check the depth of the clutch plate fingers when it was installed. We got caught with one wouldn't fully engage had to resplit it after putting the loader mounts back on a dx120. We just installed it straight out the box thinking it would be factory preset but no. When we had to...
  6. D

    Different mouse trap on u tube

    I dont know about this but have caught 1000s with a similar idea. Open top bucket half full of water and a greased up glass bottle on end of the board over the drum with cheese or peanut butter in the end as an attractant. Usually butter to grease it up.
  7. D

    Must be Monday

    Looks like the last 2 harvests in Australian except its to green. Wet wet wet and more wet dont go to far without a tow strap
  8. D

    Finally learned how to clean the mower off

    Used a blower once or twice but with a 100cfm compressor for blowing down the combine sitting in the middle of the yard dont use the blower much everything just gets pulled up at it when finshed
  9. D

    Haying on Central Oregon

    Farm road or public. I know how many irrigation pipes would still be round if I laid them that close to a public road.... none they all be squished flat
  10. D

    Irregular tire wear

    Pavement will do odd things to tires with the the changes in road camber and traffic wheel marks. We have a tractor when it was main farming tractor it wore last set of rear tyres ires bald level. Now it's down graded to spray and hay tractor. No heavy draft work lots of road work it wearing...
  11. D

    Farmall cotton pickers

    I have one of these minus the cotton heads. Brought it two years ago. It has been converted into a grass seed harvester. But still uses the basket and fans everything is original except the cotton heads. Gets lots of looks at shows and is a dog to drive
  12. D

    Re: Deutz Tractor

    Not sure but we run 6207 7207 and 3 dx series tractors. Have you looked into the lift pump. We had similar symptoms ant it was the lift pump leaking back into the sump
  13. D

    Another funny

    I wonder if the lid fits
  14. D

    deutz fuel pump

    Could always bypass it and add a electric pump like I did on a deutz tractor the other day. Was easier than trying to find a new lift pump
  15. D

    GPS Guidance System Recommendations?

    Trimble ez guide 250. Cheap and easy to use. Light bar and coverage map. Can be upgraded to steering moter at a later date
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top